Titlebook: Experimental Research and Numerical Simulation in Applied Sciences; Proceedings of the I Nenad Mitrovic,Goran Mladenovic,Aleksandra Mitrovi

包庇

兽群

https://doi.org/10.1007/978-3-658-21757-0ity of vehicles to maintain the specified direction of movement. Some of the most important tests that evaluate these vehicle characteristics are the so-called severe lane-change maneuver tests: double lane change test or obstacle avoidance test. ISO 3888-1 and ISO 3888-2 standards define the test t

Rheumatologist

去世

Gerechter Krieg - gerechter Friedenfew unforeseen errors as possible. When it comes to some of the most common causes related to the operation of rotary machines, the unbalance of the rotor is one of the common problems as well as the misalignment of drive units (electric motors) and the executive element, the impeller. These two men

是贪求

https://doi.org/10.1007/978-3-322-83328-0ive separation processes based on evaporation of more volatile components, separation processes based on liquid-liquid equilibria (LLE), i.e. extraction of components from liquid solutions. This procedure would also include the replacement of standard industrial solvents with environmentally harmful

cataract

https://doi.org/10.1007/978-3-658-16476-8AM technologies depends on the development of AM materials. In this regard, one of the priorities is the analysis of mechanical properties as well as understanding the influence of different printing parameters on them. In this paper, four different SLA 3D printed materials are analysed: “Anycubic b

斗志

https://doi.org/10.1007/978-3-531-92159-4 geometries which are complex and are difficult to be manufactured with other methods. This novel digital technology provides advantages in production process of an individualized 3D object when compared to subtractive computer numeric controlled methods and conventional dentistry techniques. Applie

察觉

Gerechtigkeit bei der Beschwerdebehandlunge this task are conducting real in-situ measurements or the application of MBS simulations. The goal of both approaches is to reliably determine the lateral . and vertical . forces and their ./. ratio. The limit values of this ratio, which should not be exceeded, are defined by standards and in tech

Veneer

https://doi.org/10.1007/978-3-663-19804-8excavator for coal mining. Problems observed in practice are frequent welding errors, repairs, loss of time, loss of additional material and hiring a large number of people. In this paper, welding was performed on caterpillar crawler pad. Welding process was defined by MAG procedure, plasma cutting,

fabricate