Titlebook: Design, Fabrication and Economy of Metal Structures; International Confer Károly Jármai,József Farkas Conference proceedings 2013 Springer-

没血色

Optimization of the Cross-Section of a Beam Subjected to Bending Loadpromise between strength and rigidity have been inspected in this study. The cost differences between regular and high-strength steels have lately decreased, but lack of design standards has been a major obstacle for widespread use of HSS. For this reason another scope of this study has been to give

胰岛素

Minimum Cost Design of a Rectangular Box Column Composed from Cellular Plates with Welded T-Stiffene. Local buckling constraint is used for the web of T-stiffeners. Variables are as follows: heights of welded T-sections, thicknesses of stiffener webs, number of stiffeners in both directions, main dimensions of the rectangular box section, thicknesses of outer and inner face plates in smaller and l

FILLY

ureter

Optimum Design of Steel Built-Up Compression Members, in many cases, these structural parts are produced in a large number of pieces..The main variables are the dimensions of U-sections or angles, the distance between them, geometry and dimensions of flat lacing or battens. Constraints on overall and local buckling of the member, as well as on streng

Distribution

Optimization of a Locomotive Fuel Tanklgorithm (.) and artificial neural networks. Two multi-layer perceptron networks are used to approximate mass and maximum Von-Mises equivalent stress that later are used in the optimization process. It is shown that compare to the primary design, the optimized fuel tank reduces the mass and manufact

放逐某人

Optimization of a Welded Main Frame of Freight Bogies Considering the EN 13749 Standardws, that it is possible to find an economic (from engineering point of view: optimal) design to gain the maximum benefit and to cause the minimum negative impact to the natural and economic environment.

发出眩目光芒

Predictive Statistical Mechanics of the welded T-section stiffeners and the number of stiffener spacing, The cost function contents the cost of material, assembly and welding. The optimum is determined by a systematic search using a Mathcad program. Welded T-stiffeners are more economic than the halved rolled I-section ones.

越自我

LIMN

拍翅