找回密码
 To register

QQ登录

只需一步,快速开始

扫一扫,访问微社区

Titlebook: Circuit and Interconnect Design for RF and High Bit-rate Applications; Hugo Veenstra,John R. Long Book 20081st edition Springer Science+Bu

[复制链接]
楼主: Racket
发表于 2025-3-25 03:35:51 | 显示全部楼层
https://doi.org/10.1007/978-1-349-25931-1rk capacity is being increased by two technologies simultaneously. One is higher data processing speeds and electronic time division multiplexing (ETDM), which drives the increase of bit-rates. The second is wavelength division multiplexing (WDM), which allows the use of multiple independent data st
发表于 2025-3-25 07:38:52 | 显示全部楼层
发表于 2025-3-25 12:30:42 | 显示全部楼层
Aniceto C. Orbeta Jr,Maria Teresa C. Sanchez rates up to 12.5 Gb/s per input. The block diagram of the switch IC is shown in Fig. 1.9. An overview of the main specifications is provided in Table 4.1..The main focus of this chapter is on the design of the RF signal path. The IC is designed for wire bonding, so all the bondpads must be located
发表于 2025-3-25 15:56:03 | 显示全部楼层
International Political Economy Serieschnology are very similar, as will be demonstrated in this chapter..The maximum speed of digital circuits in a given IC process is often benchmarked on the basis of minimum gate delays, obtained from a ring oscillator. Such a ring oscillator can be built from simple inverters and therefore provides
发表于 2025-3-25 21:23:16 | 显示全部楼层
https://doi.org/10.1057/9780333977927beyond .. in bipolar circuit implementations)..Many tuneable LC oscillators apply a cross-coupled differential pair to undamp the LC-tank circuit, leading to the basic configuration shown in Fig. 7.1.
发表于 2025-3-26 04:07:18 | 显示全部楼层
发表于 2025-3-26 04:46:57 | 显示全部楼层
The Challenge,rk capacity is being increased by two technologies simultaneously. One is higher data processing speeds and electronic time division multiplexing (ETDM), which drives the increase of bit-rates. The second is wavelength division multiplexing (WDM), which allows the use of multiple independent data st
发表于 2025-3-26 10:08:38 | 显示全部楼层
Interconnect Modelling, Analysis and Design,owest possible impedance is required for the ground path. Different implementations for the ground path exist, such as a wire, a set of wires connected in parallel, a mesh, a plane, or a combination of these..In this book, the multi-section RLC model is also referred to as a transmission line model.
发表于 2025-3-26 13:21:36 | 显示全部楼层
发表于 2025-3-26 20:35:30 | 显示全部楼层
 关于派博传思  派博传思旗下网站  友情链接
派博传思介绍 公司地理位置 论文服务流程 影响因子官网 SITEMAP 大讲堂 北京大学 Oxford Uni. Harvard Uni.
发展历史沿革 期刊点评 投稿经验总结 SCIENCEGARD IMPACTFACTOR 派博系数 清华大学 Yale Uni. Stanford Uni.
|Archiver|手机版|小黑屋| 派博传思国际 ( 京公网安备110108008328) GMT+8, 2025-6-25 11:46
Copyright © 2001-2015 派博传思   京公网安备110108008328 版权所有 All rights reserved
快速回复 返回顶部 返回列表