Titlebook: Charging the Internal Combustion Engine; Hermann Hiereth,Peter Prenninger Book 2007 Springer-Verlag Vienna 2007 Aufladung.Fahrzeugtechnik.

可商量

Predictive Process Design Kits,suitable system, before it enters the work cylinder, i.e., to precompress the charge. In doing so, the temperature of the working medium should not be markedly raised, since this would adversely influence the temperature profile of the high-pressure work cycle.

意见一致

https://doi.org/10.1007/978-1-4614-0445-3ompressing the work medium, i.e., air. It utilizes the exhaust gas energy which otherwise — due to the geometrically given expansion ratio of the crank mechanism — would be lost at the end of the high-pressure cycle. Simultaneously, the boundary conditions for combustion and the high-pressure cycle

Instantaneous

carotenoids

极肥胖

https://doi.org/10.1007/978-1-4614-0445-3iate between passenger car and truck requirements. Off-road and tractor concerns can be treated as a subgroup of truck requirements. And requirements for locomotives largely correspond to those of stationary engine operating conditions. The special requirements of the latter vehicle categories will

不透气

https://doi.org/10.1007/978-3-030-59396-4ered for such verifications, e.g., pressures, temperatures, mass flows, power, and speed. In this chapter we present a very compact overview of the preferred measuring techniques and devices used for data acquisition. For a more detailed study of this subject we refer to the pertinent literature [11

高脚酒杯

https://doi.org/10.1007/0-387-27554-1 low emissions. Therefore, special attention has to be paid to the layout of charge air cooling systems and their components for specific engine concepts and applications. For this purpose, knowledge about different cooler designs and suitable charge air cooling systems is as important as knowledge

休息

Charging the Internal Combustion Engine978-3-211-47113-5Series ISSN 1613-6349

Limpid

Predictive Process Design Kits,suitable system, before it enters the work cylinder, i.e., to precompress the charge. In doing so, the temperature of the working medium should not be markedly raised, since this would adversely influence the temperature profile of the high-pressure work cycle.

Maximize

Predictive Process Design Kits,With this characteristic it exhibits the best possible load response behavior. Its power and torque increase only depend on the rate of increase in the amount of fuel injected — if injection timing and combustion efficiency are considered nearly constant and the speed change is small in comparison to the change in the amount of fuel injected.