Titlebook: Atlas of Machined Surfaces; K. J. Stout,E. J. Davis,P. J. Sullivan Book 1990 K. J. Stout, E. J. Davis and P. J. Sullivan 1990 distance.eng

Left-Atrium

P. L. Butzer,E. Görlich,B. Sz.-Nagya highly correlated structure, generated by the rotation of the end mill as it is traversed across the surface of the material. The structure of the surface is related to the variation in surface cutting speed and the feed-rate as the cutter is traversed across the surface. The surface cutting speed

acrimony

P. L. Butzer,B. Sz.-Nagy,E. Görlichlearly shows the grinding marks caused by the cutting action of the grits attached to the periphery of the grinding wheel and the directional nature of the grinding process. The grits are held at a variety of levels in relation to the circular envelope scribed by the grinding wheel as it rotates. So

Negotiate

Colonnade

Mathematics and its Applicationsrated by the action of the single-point tool as it revolves over the surface. The correlation is caused by the feed-rate of the machine table as the workpiece is traversed under the rotating cutting tool. Due to the small area under assessment, it is not possible to easily detect the curvature relat

Insensate

https://doi.org/10.1007/978-94-015-7758-8nts or ridges parallel to each other caused by the action of a single-point cutting tool as it cuts successive grooves into the surface. The distance between each groove is related to the feed-rate of the boring tool. The tools used in these processes are typically round-nosed and this feature is ea

记成蚂蚁

On the Ranges of Additive Correspondencesed in this case by a combination of the feed-rate and the peripheral velocity of the milling cutter during the cutting process. Where there are departures from correlation of the surface structure this is due to the random action at the tool-chip interface, caused in part by the non-homogeneity with

–DOX

Zafer Ercan,Antony W. Wickstead produce a flat surface with a high quality of surface finish, i.e. a low . value. The axonometric projection (Figure 10.1) shows that such a surface often suffers from loss of form during the polishing process. This loss of form is often associated with an uncontrollable rocking action of the surfa

松驰

裂口

jumble

Marián Fabian,Petr Habala,Václav Zizler, with superimposed honing grooves running across it. These grooves are produced by the action of specially sharpened honing stones which are traversed and reciprocated under controlled action within a bore as it goes through its final machining process. These honing grooves are introduced to delibe