Titlebook: Atlas of Machined Surfaces; K. J. Stout,E. J. Davis,P. J. Sullivan Book 1990 K. J. Stout, E. J. Davis and P. J. Sullivan 1990 distance.eng

A保存的

一回合

troponins

Electro Discharge Machined Surfaceface through the di-electric fluid during the machining process. As both the distribution and the intensity of the discharge are affected by the suspension of particles in the di-electric fluid, the cavities formed on the surface have differing magnitudes. The high peaks on the surface are formed adjacent to the melted valleys.

MAUVE

有限

MIRE

Mathematics and its Applicationsing to the scribed circumference of the cutting tool as it swings in an arc across the surface. Notice the considerable micro-roughness on Figure 6.1 which is typical of the cutting action associated with single-point cutting tools.

AUGER

P. L. Butzer,E. Görlich,B. Sz.-Nagyeases from the centre to the outside. The surface cutting speed approaches zero at the centre of the tool. As the end mill is traversed across the surface of the component cutting is occurring all along the cutting edge, and hence the cutting velocity, normally termed . (feet/minute or metres/second), varies significantly.

无礼回复

interrogate

End Milled Surfaceseases from the centre to the outside. The surface cutting speed approaches zero at the centre of the tool. As the end mill is traversed across the surface of the component cutting is occurring all along the cutting edge, and hence the cutting velocity, normally termed . (feet/minute or metres/second), varies significantly.

并入