Titlebook: Engineer of the XXI Century; Proceedings of the V Stanisław Zawiślak,Jacek Rysiński Conference proceedings 2020 Springer Nature Switzerland

法令

书目名称Engineer of the XXI Century影响因子(影响力)




书目名称Engineer of the XXI Century影响因子(影响力)学科排名




书目名称Engineer of the XXI Century网络公开度




书目名称Engineer of the XXI Century网络公开度学科排名




书目名称Engineer of the XXI Century被引频次




书目名称Engineer of the XXI Century被引频次学科排名




书目名称Engineer of the XXI Century年度引用




书目名称Engineer of the XXI Century年度引用学科排名




书目名称Engineer of the XXI Century读者反馈




书目名称Engineer of the XXI Century读者反馈学科排名

碎石

Lyme-disease

欲望小妹

Flatness-Based Control Design for Two-Mass System Using Induction Motor Drive Fed by Voltage Source a two-mass system with flexible shaft, i.e., when long shaft and large load side mass are used. In this case, the oscillation caused by the finite stiffness and damping coefficients of the shaft may degrade the performance of the drive system. Hence, this paper focuses on control design for two-mass

nephritis

Mesoscopic Modelling of Unidirectional Polymer Laminate Reinforced with Glass Roving Fabricernal structure of the laminate at the level of components in a simplified way. Glass roving as part of fabric was modelled using beam elements while matrix was modelled in two ways—using the finite elements of beam and shell types. This model was developed for prediction of mechanical behaviour and

Exclude

Simulation of Adhesive Joint Strength in Peel Test Conditionsng has been described and the test results of the materials used for preparing specimens for tests have been presented. In the program based on FEM, a solid model has been made, in which the contact layer is based on a CZM type material model. The results of experimental studies have been compared w

Exclude

Effect of Heat Treatment on Tensile Properties and Hardness of a Forging Made of EN AW-6082 Alloyment) on obtained values of mechanical properties (R., HB10/1000/30) of a forging used as component of a fixture to aerial electrical supply lines, produced from EN AW-6082 alloy (according to PN-EN 373-3:2014-02). Temperatures of solutioning (520–540 ℃) and ageing (160–180 ℃) operations were select

媒介

Modelling of Bending Pre-compressed Beams Made of Resin L285 defining the warp and reinforcement constituting their structure. This article analyzes a composite consisting of polyamide reinforcement and L285 epoxy resin. The results of experimental studies have been compared with the results of computer simulation, using the finite element method (FEM). Mate

considerable

债务

Studying the Dynamic Properties of an Amplifier Board Execution Block in Terms of False Tripping of ed in SSP-FK aircraft fire suppression systems. An SSP-FK fire suppression system (as one of the main onboard protection systems) used on many types of military aircraft operated in the Polish Armed Forces. The results of statistical analyzes regarding the type of disability, their symptoms and caus