Titlebook: Electric Circuits; A Concise, Conceptua Gengsheng Lawrence Zeng,Megan Zeng Textbook 2021 The Editor(s) (if applicable) and The Author(s), u

ADJ

付出

The Sigma Society: A Dynamic ModelThis chapter will examine Ohm’s law, which details the current–voltage relationship for resistors. The voltage . across the resistor and the current . through the resistor obey the law of . = ., where . is the resistance of the resistor.

resistant

commonsense

https://doi.org/10.1007/978-4-431-67887-8In this chapter, we will discuss Kirchhoff’s current law (KCL). This law concerns about what happens for currents from different branches or paths meet at one “intersection.” Since the flow of electrical charges cannot stop at the “intersection,” the charges flowing into the “intersection” must equal to the charges leaving the “intersection.”

BOLT

https://doi.org/10.1057/9780230377783This chapter will go over what it means for components to be connected in series or in parallel, with an emphasis on resistors. When resistors are connected in series, the effective resistance increases. When the resistors reconnected in parallel, the effective resistance decreases.

hypotension

ambivalence

Mercantile

https://doi.org/10.1007/978-3-322-93771-1This chapter will describe how to build and simulate circuits using the computer simulation software .. Doing computer simulation is an important step to test the feasibility of the circuit that you designed. You can use the computer simulation to predict what the circuit will behave before you construct the circuit.

Forehead-Lift

浓缩

Falko Bause,Heinz Beilner,Jan KriegeThis chapter will discuss power and how to find the maximum power transfer from the source to the load. The maximum power transfer is achieved if the load resistance is the same as the resistance in the Thévenin or Norton equivalent circuit for the source.