Titlebook: Advances on Mechanics, Design Engineering and Manufacturing III; Proceedings of the I Lionel Roucoules,Manuel Paredes,Caterina Rizzi Confer

Hirsutism

Develop Model for Controlled Depth Milling by Abrasive Water Jet of Ti6Al4V at Jet Inclination Angleit produces low cutting forces and heat generation and prevents deformation of these parts after machining. In addition, it has the advantage of only using two raw materials: sand and water. It is possible to generate pocket edges with an imposed geometry using AWJM, but it is necessary to tilt the

deface

Cold Working Process on Hard Metal Stacked Assemblyparts. Although its application has been well tested on aluminum assemblies, hard metal applications are still being studied. This paper presents experimental results of double bolt joint assemblies under double shear fatigue tests after stacked split sleeve cold expansion. The behaviors of two size

尖酸一点

Numerical Simulation and Experimentation of Additive Manufacturing Processes with Polyurethane Foamsa high-pressure machine. This inexpensive technology allows large parts to be produced in a reduced time. However, the quality of the parts produced by the FAM technique is greatly affected by the various thermal phenomena present during manufacturing and by the geometrical deviations of the layers

Expostulate

Analysis of Warpage Induced by Thick Copper Metal on Semiconductor Deviceepresenting a relevant improvement from the state of art because of its excellent electrical and thermal conductivity compared with traditional compound such as aluminum. The main technological factor that makes challenging the industrial implementation of thick copper layer is the severe wafer warp

SOB

无聊的人

Collision

Topology Optimization Design of Internal Reinforcements in a Sailing Dinghye the hull of a sailing dinghy. This process assumes that the inner volume included between the hull and the deck is, at the beginning of the simulation, filled with material; then a portion of this inner volume is eroded until a final free form shape of the reinforcements is obtained. A key point o

神刊

推测

Topological Optimization of a Mechanical System with Adaptive Convergence Criterion. How can be optimized a mechanical system in which each optimized part changes the boundary conditions? A Design method called TOMS (Topological Optimization of a Mechanical System) has been developed to take into account the variation of the boundary conditions when optimizing parts. When the usin

Celiac-Plexus

Design for Additive Manufacturing of a Topology Optimized Brake Caliper Through CAD-Platform-Based S process of a Formula SAE front brake caliper has been performed, to be printed by Powder Bed Fusion (PBF) process. The DfAM consists in the use of a Ti6Al4V titanium alloy to better resist at high temperatures and a topology optimized shape allowed by the technology to save weight despite the densi