Titlebook: Advances in Modern Machining Processes; Proceedings of AIMTD M. S. Shunmugam,Biswanath Doloi,A. S. Prasanth Conference proceedings 2023 The

极力证明

瘙痒

archaeology

沙漠

Comparative Evaluation of Machining Performance of Nimonic 263 in Powder Mixed EDMning (PMEDM) process. Material removal rate (MRR), tool wear rate (TWR), and average surface roughness (R.) of the machined surface are the performance parameters used to evaluate the machining performance both with normal and reverse polarity. Pulse duration (T.), peak current (IP), and duty factor

miniature

Effect of Peak Current and Pulse-On Time on MRR and TWR in EDM of Ti-6Al-4 V titanium, tungsten, etc. It removes the material from the workpiece by a series of sparks and the spark vibrancy depends on various parameters. Material removal rate and tool wear rate are used to determine the performance of any machining process. In case of EDM, MRR is very low and depends on var

男生戴手铐

Comedienne

Enhancement of MRR of Inconel 718 During EDM by Numerical and Experimental Approaches more realistic results, a Gaussian distribution of heat flux had employed. ANSYS APDL21R1 was used for the simulation of the developed thermal model. Temperature distribution Profile of workpiece was used to find the radius and depth of cavity at 100% PFE. Actual dimensions of cavity were calculate

thwart

Fresco

Experimental Investigations into Erosion of Zinc-Coated Brass Wire Electrode During WEDM of Ti-6Al-4f industrially important Ti-6Al-4 V alloy. Wire erosion and breakage pose a serious environmental threat as it increases the energy consumption and machining time of the process. A deeper knowledge of the wire wear mechanism and its responsible factors shall provide valuable insights to achieve sust

戏服