Titlebook: Single- and Two-Phase Flow Pressure Drop and Heat Transfer in Tubes; Afshin J. Ghajar Book 2022 The Editor(s) (if applicable) and The Auth

Etymology

Heat Transfer Results in Plain Tubes with Different Inlet Configurations tube across all flow regimes (laminar, transitional, and turbulent). The effect of inlet configuration (square-edged, re-entrant, and bell-mouth) and buoyancy on heat transfer in different flow regimes is presented in this chapter. In addition, the variation of local Nusselt number along the tube i

Humble

苦笑

Friction Factor Results for Micro-fin Tubese and fully developed regions of the micro-fin tubes, the effect of inlet configuration and heating on the entrance and fully developed friction factors in all flow regimes (laminar, transitional, and turbulent), the effect of inlet configuration (square-edged and re-entrant) on the start and end of

放逐某人

变态

Heat Transfer Results in Micro-fin Tubes-fin tubes, the effect of inlet configuration (square-edged and re-entrant) and buoyancy on the entrance and fully developed heat transfer in all flow regimes (laminar, transitional, and turbulent), the effect of inlet configuration on the start and end of transition of the fully developed heat tran

雪白

删除

凹处

Modeling of Stratified Flowin this chapter are the flat surface model, apparent rough surface model, and the double circle model. An illustrative example demonstrating the use of these three models in determining the void fraction and two-phase frictional pressure drop in stratified flow is also provided.

沙发

Single-Phase Flow Experimental Setup for Plain and Micro-fin Tubesf starts) on friction factor (isothermal and non-isothermal) and heat transfer in the entrance and fully developed regions of horizontal plain and micro-fin tubes in all flow regions (laminar, transitional, and turbulent).

拔出