Titlebook: Simulated Evolution and Learning; 7th International Co Xiaodong Li,Michael Kirley,Yuhui Shi Conference proceedings 2008 Springer-Verlag Ber

lactic

就职

Cassandra X. H. Tang,Henry C. W. Lauout relevant aspects of additive manufacturing categories used in multi-step AM toward sinter-based parts, namely vat photopolymerization (VPP), material extrusion (MEX) and binder jetting (BJ). In principle, these AM technologies are generally similar in utilizing a polymeric binder material as mat

拱墙

问到了烧瓶

Piotr Switalski,Franciszek Seredynsking progressed, an increase in mass and volume was accompanied by a decrease in residual stress at break. In addition to the chemical composition, the “form factor” offers a variety of possibilities to influence not only the mechanical material properties but also the swelling behavior.

Ophthalmoscope

noxious

Changhe Li,Shengxiang Yanga part-scale FE model for PBF-LB/M simulation. A refined super layer approach was used to capture local shrinkage effects at abrupt part cross-section changes and an iterative, non-uniform compensation approach helped to minimize the distortions. Thin-walled artifacts were printed from AlSi10Mg powd

吊胃口

单片眼镜

cathartic

Vertical