Titlebook: Reliability for Engineers; An Introduction Michael Beasley Textbook 1991Latest edition M. Beasley 1991 design.maintainability.reliability.q

Baleful

书目名称Reliability for Engineers影响因子(影响力)




书目名称Reliability for Engineers影响因子(影响力)学科排名




书目名称Reliability for Engineers网络公开度




书目名称Reliability for Engineers网络公开度学科排名




书目名称Reliability for Engineers被引频次




书目名称Reliability for Engineers被引频次学科排名




书目名称Reliability for Engineers年度引用




书目名称Reliability for Engineers年度引用学科排名




书目名称Reliability for Engineers读者反馈




书目名称Reliability for Engineers读者反馈学科排名

腼腆

monogamy

Introduction, are chiefly in the telecommunications field although the principles introduced here can be used much more widely. From our viewpoint the study of reliability needs a combination of electrical engineering (for system analysis), statistics (for the analysis of failure data), and probability theory (for the prediction of failure patterns).

Frequency

Product Development,ife-cycle cost) and reliability. The flowchart shown in Figure 2.1 relates to the design phase before a model has yet been built. Reliability studies should be introduced as early as possible in this design phase since modifications introduced at later stages in the development are costly and time-consuming.

Ballad

系列

System Reliability, predicting the reliability of the simplest type of system, the series reliability system, using component failure data. Chapter 7 briefly describes methods of increasing system reliability and then Chapters 8 and 9 give reliability prediction methods for the more complex fault-tolerant systems.

MIRE

BLA

扔掉掐死你

how to use both hardware and software failure rates and the project manager will learn about the pitfalls of reliability demonstration testing. The background to the theory and practical examples is largely taken from electrical and electronic engineering, but the basic theory and practical advice are relevant to all forms of engineering.

惹人反感

,The Statistics of Failure — II,nd confidence intervals for CFR components make up most of the remainder of the chapter. Sections 4.2 to 4.7 inclusive contain general plotting methods. Section 4.8 deals with CFR components only. Section 4.9 indicates briefly how reliability parameters for non-CFR components may be estimated.