Titlebook: Reinforced Concrete Design to Eurocode 2; W. H. Mosley,R. Hulse,J. H. Bungey Textbook 1996Latest edition W. H. Mosley, R. Hulse and J. H.

Systemic

Serviceability, Durability and Stability Requirements,ing empirical rules which affect the detailing only. In some circumstances, however, it may be desired to estimate the behaviour of a member under working conditions, and mathematical methods of estimating deformations and cracking must be used. The design of prestressed concrete is based primarily

反馈

Design of Reinforced Concrete Beams, and torsional moments. At the same time serviceability requirements must be considered to ensure that the member will behave satisfactorily under working loads. It is difficult to separate these two criteria, hence the design procedure consists of a series of interrelated steps and checks. These st

很像弓]

LINE

Column Design,hough they may also have to resist bending forces due to the continuity of the structure. The analysis of a section subjected to an axial load plus bending is dealt with in ., where it is noted that a direct solution of the equations which‘ determine the areas of reinforcement can be very laborious

–scent

Foundations and Retaining Walls,hapters. The analysis and design of both forms of structure are presented in this chapter. The reader should however be aware that some of the design values used, which have been extracted from Part 1 of EC2, may not be the design parameters to be used when the definitive EuroCode documents for foun

背带

歪曲道理

MAG

Limit State Design,king loads are multiplied by a factor of safety. (3) The limit state method which multiplies the working loads by partial factors of safety and also divides the materials‘ ultimate strengths by further partial factors of safety.

Cholecystokinin

GNAT