| 书目名称 | Near-Net Shape Manufacturing of Miniature Spur Gears by Wire Spark Erosion Machining |
| 编辑 | Kapil Gupta,Neelesh Kumar Jain |
| 视频video | |
| 概述 | Covers near about every aspect i.e. quality, cost and competitiveness of miniature gear manufacturing using the wire spark erosion method.Presents quality aspects of gears and WSEM effects with the he |
| 丛书名称 | Materials Forming, Machining and Tribology |
| 图书封面 |  |
| 描述 | This work describes an experimental investigation with the aim to evaluate and establish wire spark erosion machining (WSEM) as a viable alternative for high quality miniature gear manufacturing. External spur type miniature brass (ASTM 858) gears with 12 teeth, 9.8 mm outside diameter and 5 mm face width were manufactured by WSEM. The research work was accomplished in four distinct experimental stages viz., preliminary, pilot, main and confirmation. The aim, scope and findings of each stage are progressively presented and discussed. In essence, the investigation found that it was possible to manufacture miniature gears to high quality by using WSEM. Gears up to DIN 5 quality with a good surface finish (1.2 µm average roughness) and satisfactory surface integrity were achieved. The results suggest that WSEM should be considered a viable alternative to conventional miniature gear manufacturing techniques and that in some instances it may even be superior. This work will prove useful toresearchers and professionals in the field of miniature and micro-scale manufacturing and machining. |
| 出版日期 | Book 2016 |
| 关键词 | Wire Spark Erosion; Miniature Gear; Gear Manufacturing; Surface Integrity; Geometric Accuracy |
| 版次 | 1 |
| doi | https://doi.org/10.1007/978-981-10-1563-2 |
| isbn_softcover | 978-981-10-9387-6 |
| isbn_ebook | 978-981-10-1563-2Series ISSN 2195-0911 Series E-ISSN 2195-092X |
| issn_series | 2195-0911 |
| copyright | Springer Science+Business Media Singapore 2016 |
发表于 2025-3-21 17:03:47
