Titlebook: Mechanical Fatigue of Metals; Experimental and Sim José A.F.O. Correia,Abílio M.P. De Jesus,Rui Calça Conference proceedings 2019 Springer

Obvious

GLOSS

Mean Stress Effect on Fatigue Behavior of Austenitic Stainless Steel in Air and LWR Conditions-controlled fatigue tests with cylindrical hollow specimens. Positive (+10, +50 MPa) and negative (−10, −20 MPa) mean stresses were applied and both showed beneficial influence on fatigue life due to cyclic hardening, which results in smaller strain amplitude under the same stress amplitude. The inc

orthopedist

Characterization of the Fatigue Behavior of Mechanical and Thermal Aged Austenitic Power Plant Steelrce- and time-optimized approach based on non-destructive testing methods is used. Beside investigations on AISI 347 austenitic stainless steel under cyclic loading, magnetic, resistometric and electrochemical measurement techniques were applied to monitor the proceeding fatigue behavior. Qualitativ

amphibian

As-Built Sharp Notch Geometry and Fatigue Performance of DMLS Ti6Al4Vly machined parts. Application of lightweight design tools results in complex part geometries with notches, reentrant corners, internal surfaces that are difficult to inspect and whose surface finish may not be improved. To efficiently investigate the fatigue response of as-built DMLS Ti6Al4V in the

最高峰

intoxicate

钉牢

Concomitant

CLAMP

SLING

Review of Current Progress in 3D Linear Elastic Fracture Mechanicsfocus of this contribution is on the situations where the classical results, which are normally obtained within the framework of plane theory of elasticity, lead to peculiar results. These situations include analysis of stress and displacement fields near vertex points, generation of the coupled fra