Titlebook

得罪人

Fostering Ways-of-Giving Within Communitiesise system (ANS). The ANS has two accelerometers and one microphone per secondary speaker. The microphone is located in the near sound field of the secondary loudspeaker. One accelerometer is fixed onto the loudspeaker cone. The other accelerometer is attached to the noise source. The control algori

凝视

Tone Dyrdal Solbrekke,Ciaran Sugruefixed frequency is stable to some extent measured at the position of error microphone, by producing the some amplitude wave with negative phase through the secondary source (the active control speaker), the noise at the position of error microphone will be greatly reduced. To reduce more than one po

挣扎

Learning Transformational Leadershiption comfort in wooden-based buildings is, however, still a challenging task. Wood is high in both strength and stiffness in relation to its weight, but its variability has repercussions on how sound propagates, this triggering sound insulation problems. Even if buildings comply with present-to-day

推测

Identities, Pathologies and Power Relations,vestigations are needed. In order to grasp the vibration and acoustic feature of flat and curved CFRP laminated plates with orthotropy, the difference from isotropic material such as steel is clarified using experimental modal analysis. As a result CFRP is found to possess a dominant radiating sound

Exuberance

https://doi.org/10.1007/978-3-642-30586-3 fixed and there are sliding contact between the pads and the disc. In the most common used complex eigenvalue analysis method, the moving load nature was normally ignored. In this paper a modal based rotating disc model is purposed. Modal parameters of stationary disc were calculated from finite el

paroxysm

Introduction to VMware Workstation Pro,easonable accuracy is in urgent need. In this paper, a two stage validation method of closed-loop coupling disc brake model for squeal analysis using complex eigenvalue analysis is presented. At component level, finite element (FE) models are verified through the comparison of FE calculation and mod

Heart-Attack

AXIOM

分离

跳动

https://doi.org/10.1007/978-94-6209-119-1It is supposed to be light weight and at the same time stiff enough to minimize deformation of the rotor outer surface caused by electro-magnetic forces in the air gap. Reducing weight without compromising the stability and stiffness of the generator requires an in-depth analysis of the dynamic beha