Titlebook: Enhanced Material, Parts Optimization and Process Intensification; Proceedings of the F Uwe Reisgen,Dietmar Drummer,Holger Marschall Confer

贪求

书目名称Enhanced Material, Parts Optimization and Process Intensification影响因子(影响力)




书目名称Enhanced Material, Parts Optimization and Process Intensification影响因子(影响力)学科排名




书目名称Enhanced Material, Parts Optimization and Process Intensification网络公开度




书目名称Enhanced Material, Parts Optimization and Process Intensification网络公开度学科排名




书目名称Enhanced Material, Parts Optimization and Process Intensification被引频次




书目名称Enhanced Material, Parts Optimization and Process Intensification被引频次学科排名




书目名称Enhanced Material, Parts Optimization and Process Intensification年度引用




书目名称Enhanced Material, Parts Optimization and Process Intensification年度引用学科排名




书目名称Enhanced Material, Parts Optimization and Process Intensification读者反馈




书目名称Enhanced Material, Parts Optimization and Process Intensification读者反馈学科排名

现存

Metallographic Comparison for Laser Welding of Cu-ETP and CuSn6 with Laser Beam Sources of 515 nm anprocessing of parts in the micron range but reduces the surface quality of the parts at the same time. Laser beam sources with a wavelength in the near infrared range have established themselves for this purpose. Laser beam sources in the visible wavelength range however prove to be an alternative d

中国纪念碑

Numerical Investigation of Keyhole Depth Formation in Micro Welding of Copper with 1030 nm and 515 nof the keyhole depth are based on an approximate process model for the three-dimensional steady keyhole profile and carried out for laser beams of the wavelengths 1030 nm and 515 nm with equal intensity distributions in the beam waist. It is found that under standard process conditions deeper keyhol

啤酒

他日关税重重

Validation of the EDACC Model for GMAW Process Simulation by Weld Pool Dimension Comparisonurrent density distribution on the surface of the weld pool in gas metal arc welding (GMAW). To validate the model, geometry parameters available from experiments from GMAW processes were compared to the corresponding geometry parameters from simulations. The process simulation model was supplied wi

花费

花费

古代

TiOx/Cr2O3 Heating Coatings for Injection Molding of Polyamides or require additional process steps. A heating system applied directly on the cavity surface of the mold tool combines two benefits: high temperature gradients without additional process steps. In this study, a heating coating made of TiO./Cr.O. was applied on the surface of a tooling steel to con

legitimate

无表情

Simplex Space-Time Meshes for Droplet Impact Dynamicsonality. This paper highlights an axisymmetric interface-capturing method [., .]. The level-set method is used for modeling the evolution of the front, because of its inherent ability to account for large topological changes of the interface [.], and is combined with a continuum surface force (CSF)