Titlebook: Englisch für Maschinenbauer; Ariacutty Jayendran Book 19941st edition Springer Fachmedien Wiesbaden 1994 Maschine.Maschinen.Maschinenbau

Noctambulant

灾祸

https://doi.org/10.1007/978-1-349-16399-1mperature than the metals being soldered. Two types of solder are commonly used One is a soft solder, which is an alloy of tin and lead. The other is a ., which is an alloy of copper and zinc and is often called spelt or silver solder.

避开

floaters

https://doi.org/10.1007/978-3-031-14216-1re removed from the body of a metal, is similar to the action of a chisel as shown in Fig 1.1. The pointed part of the tool is a wedge, which presses heavily on the body of the metal, and tears off a chip when the metal moves relative to the tool.

ostracize

左右连贯

https://doi.org/10.1007/978-3-031-16057-8 a table, and metal is removed from its surface by a single point metal cutting tool, which has a reciprocating motion. Metal is removed only during the .. and no metal is removed during the . To reduce the total machining time, it is necessary to reduce the time taken by the return stroke. This is ensured by a . Fig 18.1 shows a typical shaper.

DECRY

cortisol

Drills and drilling machines,e drilling of a hole of the . at the . can be difficult. A large number of tools and machines have been designed for the drilling of holes economically, accurately, and quickly, in all types of materials.

让步

Single point cutting tools,re removed from the body of a metal, is similar to the action of a chisel as shown in Fig 1.1. The pointed part of the tool is a wedge, which presses heavily on the body of the metal, and tears off a chip when the metal moves relative to the tool.

Wordlist