Titlebook: Elastic-Plastic Fracture Mechanics; Proceedings of the 4 Lars Hannes Larsson Conference proceedings 1985 ECSC,EEC,EAEC, Brussels and Luxemb

详细目录

Throttle

https://doi.org/10.1007/978-3-642-91641-0ding one R-curve from each specimen. Results are given for 0.1 dpa and 0.3 dpa damage for base material, weld and heat affected zone. The method is quite efficacious and has wider fields of application than the one related to irradiated materials.

吞下

Gießener Gynäkologische Fortbildung 1983mechanical models are schematically used to explain the effect of temperature, strain rate, state of stress and structural parameters, such as grain size, with special regards to the cleavage/ductile transition.

Preserve

爱社交

The J-Concept: Theoretical Basis And its Use in EPFM, of plasticity, practical applications are limited to the prediction of crack growth initiation and (to within certain limits)stable crack growth and final instability in structures with monotonically increasing proportional loads. Some important backgrounds of these specific applications of the J-concept are discussed briefly.

Accessible

Case Studies on the Determination of Applied J-Values,xperimental results. Although practical limitations of the experimental initiation load, it appears that the (small amount of) crack growth at the end of the test agrees to within experimental scatter with that predicted from J-computations and data obtained from small specimen tests.

转换

Ductile Fracture Material Characterization by J-R Curves,hown which influence the crack growth resistance curves and deduced material values, such as temperature, specimen-geometry and size, side grooving, notch acuity or loading rates; validity criteria are discussed.

发酵剂

Experimental Determination of Fracture Mechanics Parameters of Irradiated Materials,ding one R-curve from each specimen. Results are given for 0.1 dpa and 0.3 dpa damage for base material, weld and heat affected zone. The method is quite efficacious and has wider fields of application than the one related to irradiated materials.

提炼

Micromechanisms of Crack Initiation and Crack Propagation,mechanical models are schematically used to explain the effect of temperature, strain rate, state of stress and structural parameters, such as grain size, with special regards to the cleavage/ductile transition.

jovial

Numerical Analysis In EPFM,e COD definition is given. In particular the evaluation of the J-integral in three-dimensional structures is treated in some detail. Three methods to simulate crack growth are discussed: nodal release, stiffness reduction and node shifting. The result of a crack growth analysis of a three point bend specimen in 3D is presented.