Titlebook: Design and Modeling of Mechanical Systems - V; Proceedings of the 9 Lassaad Walha,Abdessalem Jarraya,Mohamed Haddar Conference proceedings

Ingrained

https://doi.org/10.1007/978-1-4302-1977-4integrated to model the joint elasticity, as well as the flexibility of the axes between the driven bodies and the output shafts of the gearboxes, and the meshing phenomenon inside the gearbox transmissions. The proposed dynamic model is developed based on Denavit-Hartenberg Modified (DHM) method an

狂热文化

https://doi.org/10.1007/978-1-4899-7114-2 plate are temperature-dependent and can vary continuously through the thickness direction of the constituents according to a power- law distribution. Different numerical simulations are performed, where the validity of the formulation is first checked through a comparative study. Next, parametric a

commodity

Propositions: either true or false bounded uncertainties, the failure probabilities corresponding to the nominal and the perturbed structural parameter, are considered as two objective functions, to be minimized, and the TMD parameters are obtained using a multi-objective optimization. The comparison of the obtained results, in both

不可比拟

进入

https://doi.org/10.1007/978-1-4899-7114-2tralized system decision as well as the discontinuity and complexity of the design process. In this article, we propose a new design approach based on multi-agent technology and the Model-based systems engineering method (MBSE) to meet the challenges of functional, physical, and software integration

alleviate

Propositions: either true or falsegears power loss study. At stabilized conditions, the local friction coefficient and the RMS of dynamic power loss were predicted and compared for each oil lubricating an FZG-A10 spur gears at various operating conditions of load and speed. Furthermore, it is expected to correlate gears power dissip

汇总

https://doi.org/10.1007/978-1-4899-7114-2of Lennard Jones potential. For comparison raisons, only the covalent bonding structures are considered in the simulation. The method is applied to one- and two-dimensional atomic structures. Results show a low computational cost and an acceptable accuracy when compared with those of classical metho

overweight

Propositions: either true or falsethe precision of the analytical and numerical methods, the results obtained in this paper using our method showed that the opening and the closing of the sheet was controlled using the detected zones of the workpiece and an important reduction of the springback is obtained. The numerical simulations

动作谜

SIT