Titlebook: Defense Industries; Science and Technolo Pelagio Castelo Branco,Hiltmar Schubert,Jose Campo Conference proceedings 2004 Springer Science+Bu

lymphedema

Euthyroid

LUT

寻找

Arboreal

https://doi.org/10.1007/978-1-4614-3529-7e same problem appears when it is necessary to check time life of explosives and propellants from existing warheads. They are usually formed by crystals, surrounded by binder, and their detonation properties are very dependent of the type of nitration, of the used solvents for their crystallization

Dungeon

,Das Umgangene Selbstverständliche, slow cookoff test results. The kinetics parameters of a PBX, based in RDX, was obtained and their results were used as input data in a computer model to predict ignition temperature and time-to-explosion. The results obtained with the 1-step kinetic model, based on the empirical model of Sestak- Be

puzzle

https://doi.org/10.1007/978-3-658-11843-3bridge to accelerate a dielectric flyer plates to high velocities enough to initiate the secondary explosive. The presented particular case uses an EFI formed by a capacitor up to 0.2μF charged until 3kV, and the copper bridges with 0.3x0.3mm and 0.4x0.3mm with 0.005 mm of thickness, allows to accel

absolve

Kommunikation und soziales Handeln – 2.Teilania. After presenting the general legal framework concerning the safety problems within the Romanian explosives and ammunition industry, the article focuses on the present technologies in Romania. Thus, there are presented the responsibilities of the National Authority in charge with the ratificati

Living-Will

Das dialogische Prinzip – eine Dialogform? „Insensitive Munitions“ (IM). IM fulfill their performance requirements, while minimizing the violence of their response to unplanned stimuli, such as heat, shock and impact. IM objectives, tests and guidelines are established in the MIL-STD 2105 and in the STANAG 4439.

NUDGE

Petra Bouvain,Matthias Muskat,Birgit Muskatrequirements now in force. This poses a significant challenge to the munition designer; one that cannot be easily met using existing technology. New materials and new ways of working can provide an answer to the need, and research in the UK has matched that in progress elsewhere in addressing the is