Titlebook: Current Problems and Ways of Industry Development: Equipment and Technologies; Olga G. Shakirova,Oleg V. Bashkov,Akhmet A. Khusai Conferen

屈尊

ERINNERUNGEN an Wolfgang Gentnerusing the climate chamber; the surfaces were visually inspected after the test. The samples surface quantitative chemical composition was determined. The samples surface roughness was contact measured..: surface dressing by ceramic granules RXX 15/15 using process equipment Rosler during 80 и 160 mi

极肥胖

ERINNERUNGEN an Wolfgang Gentnerf layers of heat-protective coating and changing the geometry of the cooling channels. Applying the results of calculating the cooling parameters will allow you to control the flow of the cooling process.

Fresco

https://doi.org/10.1007/978-3-540-33701-0tion of the topology volume, the number of rods approximating the inner region of the stamp, and also the geometric characteristics of the rods, namely, the height and cross section, are presented..: Using the presented patterns will significantly optimize the material costs for the manufacture of f

evince

BATE

摇摆

要塞

欺骗手段

载货清单

Goblet-Cells

https://doi.org/10.1007/978-3-540-37192-2 its terminal points, is greater than the power factor of controlled rectifiers with natural thyristor commutation. Control frequency pass band for circuit level 0.7 of the electric drive with a single-phase bridge-circuit rectifier with natural valve commutation is not less than 5 Hz; and for the c