Titlebook: Burrs - Analysis, Control and Removal; Proceedings of the C Jan C. Aurich,David Dornfeld Conference proceedings 2010 Springer-Verlag Berlin

边缘

Cutting Force Model for Analysis of Burr Formation in Drilling Processe cutting force based on the minimum cutting energy. Because the burr occurs on the backside of the machined plate in drilling, burr formation is associated with the axial component of the cutting force at the exit of the drill from the workpiece. The chip should also be controlled to flow toward th

Ophthalmoscope

Burr Formation in Microstructuring ProcessesInstitute of Production Engineering and Machine Tools (IFW), a fly-cutting process is used for manufacturing microstructures. These structures are used to improve the tribological performance of thermo mechanically highly stressed surfaces. The structures thus produced are able to hold some lubrican

爱国者

Analytical Modeling and Experimental Investigation of Burr Formation in Grinding such as grinding. In the presented paper the burr formation process at the workpiece edges during surface grinding is analyzed. Based upon a geometrical examination of the macroscopic contact situation between grinding wheel and workpiece, a qualitative analytical process model of burr formation is

chronicle

Developing a Process Model for Abrasive Flow Machiningedges. Using AFM, it is possible to deburr complex shaped intersecting holes and to realize pre-defined edge rounding on any brittle or hard material. Moreover it is easy to integrate into an automated manufacturing environment. Reproducibility of results saves various time and cost consuming manual

宽度

DEVIL

羊齿

Burr Formation in Drilling Intersecting Holesformation especially in regard of intersecting holes. This paper presents an approach to control burr formation concerning reproducible generation of burrs depending on intersecting geometry and process parameters. Therefore two process models describing burr formation and burr cap formation and res

cancellous-bone

挡泥板

Size Effects in Drilling Burr Formationdustries. Mostly, the manufacturing of a through bore-hole is attended by the formation of an entrance and an exit burr. Thereby, the dimension of the exit burr exceeds the entrance burr considerably. Due to the hangover on the drill exit surface, the quality of the workpiece is reduced significantl

汇总