Titlebook: Bulk Materials Handling Handbook; Jacob Fruchtbaum Book 1988 Springer Science+Business Media New York 1988 engine.material.materials.organ

高度表

Screw Conveyors,nd smooth in the rolling process. The fighting is secured to the pipe by end lugs welded to the back face of the flights and by intermediate spaced welds (see figure 4.1). For more information and data on larger sizes, refer to CEMA Book No. 350.

DECRY

Flight and Drag Conveyors,rial along; therefore, abrasive materials should not be handled by this type of conveyor, unless the speed of the conveyor is very low. Material can be discharged at any point along the trough through gates or at the end of the trough. See figure 6.1 for typical flight conveyors. Operating speed should not exceed 100 fpm.

Vulnerary

Wire Mesh Conveyors, while they pass through freezing chambers. Meat packing, including seafood, also is handled in this way. The wire cloth does not retain any small scraps, and is not affected by changes in temperature. Where food is involved, the cloth is made of stainless steel.

打火石

Compass

江湖骗子

Bucket Elevators,ets are used to elevate (usually vertically) pulverized, granular, or lumpy materials. The material is received at the boot, raised and then discharged by passing over the head wheel at the top, into a discharge chute. Generally this mechanism is enclosed in a casing, especially the head and foot se

Assault

thrombus

Apron and Mold Conveyors,double strand of steel strap roller chain and riding on single-flanged rollers. They operate horizontally or at inclines up to about 25°, sometimes even 30°, from the horizontal, depending on material and size of lumps They can be made in heavy-or light-duty designs, depending upon the severity of s

Default

inhumane