Titlebook: Applied Chemical Process Design; Frank Aerstin,Gary Street Book 1978 Plenum Press, New York 1978 design.development.engine.engineering des

拥护者

Alexandre Cavalcante,Allison J. GonsalvesThe chemical composition of metals commonly used in the process industries is listed in Table 10.1. Typical appllcations for these metals are given in Table 10.2.

删减

https://doi.org/10.1007/978-3-031-21398-4Use the procedure outlined in Figure 13.1 topredict pump requirements. See Section 6.1 to obtain equivalent lengths of fittings and to calculate line loss per foot of pipe due to friction.

箴言

Cooling Towers,This chapter outlines a procedure that may be used to select an induced draft cooling tower as normally used in process plants.

GOAT

FLAX

重画只能放弃

巧办法

Hydroclones,Typical design dimensions for commercial hydroclones are shown in Figure 9.1.

Mundane

我就不公正

Pump Sizing,Use the procedure outlined in Figure 13.1 topredict pump requirements. See Section 6.1 to obtain equivalent lengths of fittings and to calculate line loss per foot of pipe due to friction.

引导