Titlebook: Advanced Manufacturing and Automation X; Yi Wang,Kristian Martinsen,Kesheng Wang Conference proceedings 2021 The Editor(s) (if applicable)

Ostrich

Klaus Sachs-Hombach,Klaus Rehkämperperimental results, it can be concluded that simulation results are reasonable. Based on the model, the influences of the milling speed vc, the axial milling depth ap, the per-feed feed rate fz on the milling force are analyzed. The temperature field distribution at different milling speeds and the

Insubordinate

Josef Heinrich Meyer-Fujara,Hannes Rieser power transmission error. The Gear Trax software has been used to model the gear with different amounts of backlash (from 0 mm to 1 mm by 0.2 mm increments) so that this gives a backlash due to the reduction of the thickness of the gear tooth. A plane strain analysis is used to predict the static t

Embolic-Stroke

Medienframing von Konflikten und Krisen,the problems exist in wind energy sectors i.e. higher cost, higher density, and effects in polluting the environment. This paper focuses on the study of potential of false banana/glass reinforced hybrid composites for wind turbine blade under fatigue load. The physical properties of the hybrid compo

收养

Deutsche Chinabilder im Wandel,et hydrocyclone was designed. Internal flow field of two hydrocyclones was simulated by RSM (Reynolds stress model) and Mixture model. The study shows that the V-shape outlet hydrocyclone can reduce concentration of the underflow particles with a diameter of 2.5 μm to 4.1%, which is 5.29 times lower

温室

事物的方面

临时抱佛脚

裁决

Tim Christian Lüth,Mattias Felix Trägerd is not satisfactory under multi-working conditions. First, the Transfer Component Analysis method is employed to transform the source domain and the target domain into the same space. Then annotation probability matrix is proposed for fault diagnosis. Finally, the proposed method is verified on th

填满

积云