Titlebook: Soft Computing in Information Communication Technology; Volume 1 Jia Luo Conference proceedings 2012 Springer-Verlag Berlin Heidelberg 2012

SPIR

书目名称Soft Computing in Information Communication Technology影响因子(影响力)




书目名称Soft Computing in Information Communication Technology影响因子(影响力)学科排名




书目名称Soft Computing in Information Communication Technology网络公开度




书目名称Soft Computing in Information Communication Technology网络公开度学科排名




书目名称Soft Computing in Information Communication Technology被引频次




书目名称Soft Computing in Information Communication Technology被引频次学科排名




书目名称Soft Computing in Information Communication Technology年度引用




书目名称Soft Computing in Information Communication Technology年度引用学科排名




书目名称Soft Computing in Information Communication Technology读者反馈




书目名称Soft Computing in Information Communication Technology读者反馈学科排名

歌剧等

Dongling Li,Ying He,Yunpeng Xu,Yadong Fanstrength (113 MPa) was the flax composite associated with the alkali–silane fibre surface treatment with an NaOh concentration of 5%. The most influential factor for maximizing the tensile strength was the alkali–silane fibre surface treatment, with a contribution of 53.0%.

宽敞

Yujie Li,Lifeng Zhang,Huimin Lu,Yuhki Kitazono,Shiyuan Yang,Shota Nakashima,Seiichi Serikawaion of the cap height. The results are then integrated in a numerical model built in Matlab, in order to study the electrical optimization of the harvester. Specifically, the number of turns of the coils is varied to maximize the power output produced at resonance. Finally, the same model is used wi

Inflammation

面包屑

Ting Zhang,Jingsha He,Yang Zhangrial for use in the production of a variety of objects. From the point of view of sustainability the idea is to extend the life cycle of coffee, eliminating the waste phase that usually follows consumption. The main goal to be achieved, within this research is to obtain a mouldable material, formed

FACET

Huanzhi Gao,Beiji Zou,Xiaoying Wangrial for use in the production of a variety of objects. From the point of view of sustainability the idea is to extend the life cycle of coffee, eliminating the waste phase that usually follows consumption. The main goal to be achieved, within this research is to obtain a mouldable material, formed

Cardioplegia

Zhao-yun Sun,Xiao-bing Du,Feng-fei Wang,Peng Yaname time, in contrast to PBS where salt films of insoluble products are formed on some pits. The potentiodynamic polarisation measurements show higher anodic reaction rate after a 30-days’ period of immersion in PBS and H.O. for both alloys. The dissolution of Ti, Al, and V and oxidation in 5 M HCl

Plaque

Yuanfeng Peng,Youzheng Wangder significantly improved all studied material parameters presented in this article. Therefore, this article is an extension of previous studies and brings new insights to the topic, for example time horizon of the study. The first part of this article is focused on the analysis of the pozzolanic r

期满

CUMB

Xijin Zhao,Chun Zhang,Yongming Li,Ziqiang Wang,Yuhui Here investigated. In the X-ray diffraction (XRD) patterns of the representative Mg.Zn.Ca. powder after 13 h of MA, a broad diffraction peak corresponding to the amorphous phase is noticed. The results by XRD show that the Mg.Zn.Ca. alloy after sintering has a multiphase structure. The investigated al