keloid
发表于 2025-3-28 18:03:04
Effect of Profile Geometry and Cutting Speed Override Parameter on Profiling Speed During Tapering ned profiles. The basic shapes of 1, 3, and 5 mm sides were machined. The cutting speed override parameter affected the most on profiling speed in both the angles irrespective of profiles. The profile geometry also affects the profiling speed although the machining parameters were maintained constant.
违抗
发表于 2025-3-28 19:56:57
Influence of Burnishing Process on Tensile Strength of Al7075-T6 Alloy,y; process parameters are optimized to fix the achievable maximum tensile strength for the said alloy. The results show that the burnishing process increased the tensile strength by 7% over the unburnished specimen.
裤子
发表于 2025-3-29 00:28:02
http://reply.papertrans.cn/89/8835/883410/883410_43.png
STEER
发表于 2025-3-29 04:28:36
Taguchi Experimental Design for Turning of AISI 4340 Steel and Grey Analysis on Machinability Paramf machining parameters in turning process of AISI 4340 steel by using grey relational analysis. Experiments were performed using Taguchi experimental design to reduce the number of experiments in the study. Taguchi’s L9 orthogonal array was chosen for design of experiments. Experiments were done by
设想
发表于 2025-3-29 09:26:35
http://reply.papertrans.cn/89/8835/883410/883410_45.png
accomplishment
发表于 2025-3-29 14:36:45
Multi-response Optimization of Machining Characteristics Using MQL Through GRA and TOPSIS Approach,lubrication, cooling and chips flushing. Nowadays, advanced cutting fluids like nanofluids are effectively used in machining due to its heat transfer medium at the cutting zone, and on the other hand, vegetable oil-based cutting fluids which are eco-friendly are being widely used as coolants in diff
dissolution
发表于 2025-3-29 16:46:15
An Experimental Investigation of Laser-Assisted Machining of EN24 Steel,cessive tool wear and poor surface finish. EN24 is commonly used steel in the aerospace industry where machinability for this material is limited due to their higher strength and hardness. In the present study, the laser-assisted machining process of EN24 steel was studied using a traditional
爆米花
发表于 2025-3-29 19:53:16
Optimization of Wire Cut Electric Discharge Machining Characteristics of Hybrid Aluminium Compositentage of SiC using Taguchi approach. The four process parameters chosen were pulse-on time, pulse-off time, servo voltage (V) and wire speed, and output parameters were material removal rate and surface roughness. The experiments were conducted based on Taguchi L9 (3^4) orthogonal array. The results
GROUP
发表于 2025-3-30 00:23:03
Minimum Quantity Lubrication and Cryogenic for Burnishing of Difficult to Cut Material as a Sustainng is one of the effective lubricants which can improve the surface characteristics of the material. Generally, machining under various lubrication systems is performed on difficult-to-cut materials. The material considered is 17-4 precipitation-hardenable (PH) stainless steel which is known for its
GRILL
发表于 2025-3-30 04:35:06
Investigation of Effect of EDM Process Variables on Material Removal Rate and Tool Wear Rate in Macd tool wear rate in electrical discharge machining (EDM) of hardened EN19 steel. The copper tool electrode was used for experimentation. To study the effect of parameters on process characteristics, response surface methodology and Box-Behnken experimental design were employed. The models for respon