织布机
发表于 2025-3-23 11:11:58
Multi-response Optimization of Machining Characteristics Using MQL Through GRA and TOPSIS Approach,l analysis, an optimum solution is obtained for the output responses, i.e. cutting temperature, surface roughness (Ra and Rz) and material removal rate. It was concluded that, vegetable oil showed better performance compared to nanofluid (Al.O.).
menopause
发表于 2025-3-23 14:04:54
http://reply.papertrans.cn/89/8835/883410/883410_12.png
ATRIA
发表于 2025-3-23 21:53:35
http://reply.papertrans.cn/89/8835/883410/883410_13.png
高谈阔论
发表于 2025-3-24 01:46:16
The Effect of Drilling Parameters on the Hole Quality of Hybrid Fiber-Reinforced Epoxy Composite,her used to compute the hole dimensions. The details of the pixel values at the entry and exit were measured digitally, and subsequently, the pixel values were used to determine the extent of damage occurred due to the drilling operation. A two-dimensional array of hole dimension with respect to the
异教徒
发表于 2025-3-24 06:19:07
Evaluation of Machining Properties of Short Bamboo Fiber-Based Green Composites Using CNC Drillinganalysis and ANOVA are performed for determining the influencing parameters and statistical significance of the data, respectively. The result shows that the parameters DBS and CS have contributed more effect for thrust force (TF) while input parameter CS for MRR during the machining of SBFGC. At l
Admire
发表于 2025-3-24 08:23:31
http://reply.papertrans.cn/89/8835/883410/883410_16.png
意见一致
发表于 2025-3-24 12:24:59
http://reply.papertrans.cn/89/8835/883410/883410_17.png
逗它小傻瓜
发表于 2025-3-24 18:01:55
Experimental Investigation of Vegetable Oils-Based Minimum Quantity Lubrication Grinding by Using Iof vegetable oil and ionic liquid. Surface roughness, grinding temperature, grinding forces, grinding ratio, and specific grinding energy have been selected as output parameters. The Taguchi method that uses L9 orthogonal arrays was performed to optimize the process parameter. Results revealed that
乏味
发表于 2025-3-24 21:57:32
http://reply.papertrans.cn/89/8835/883410/883410_19.png
旧式步枪
发表于 2025-3-25 00:53:52
Surface Integrity of Powder Mixed Electrical Discharge Treated Substrate at High Discharge Energiesedium significantly elevates the MRR to 58.7 mm./min. However, in the conventional electrical discharge machining, the feasibility of the process for achieving the good surface integrity was constrained at high current. Moreover, the powder mixed electrical discharge machining shifts the efficiency