lactic
发表于 2025-3-23 13:27:39
http://reply.papertrans.cn/87/8675/867484/867484_11.png
就职
发表于 2025-3-23 14:47:50
Cassandra X. H. Tang,Henry C. W. Lauout relevant aspects of additive manufacturing categories used in multi-step AM toward sinter-based parts, namely vat photopolymerization (VPP), material extrusion (MEX) and binder jetting (BJ). In principle, these AM technologies are generally similar in utilizing a polymeric binder material as mat
拱墙
发表于 2025-3-23 18:33:22
http://reply.papertrans.cn/87/8675/867484/867484_13.png
问到了烧瓶
发表于 2025-3-24 01:52:58
Piotr Switalski,Franciszek Seredynsking progressed, an increase in mass and volume was accompanied by a decrease in residual stress at break. In addition to the chemical composition, the “form factor” offers a variety of possibilities to influence not only the mechanical material properties but also the swelling behavior.
Ophthalmoscope
发表于 2025-3-24 05:07:14
http://reply.papertrans.cn/87/8675/867484/867484_15.png
noxious
发表于 2025-3-24 07:44:49
Changhe Li,Shengxiang Yanga part-scale FE model for PBF-LB/M simulation. A refined super layer approach was used to capture local shrinkage effects at abrupt part cross-section changes and an iterative, non-uniform compensation approach helped to minimize the distortions. Thin-walled artifacts were printed from AlSi10Mg powd
吊胃口
发表于 2025-3-24 12:37:15
http://reply.papertrans.cn/87/8675/867484/867484_17.png
单片眼镜
发表于 2025-3-24 15:26:50
http://reply.papertrans.cn/87/8675/867484/867484_18.png
cathartic
发表于 2025-3-24 19:31:14
http://reply.papertrans.cn/87/8675/867484/867484_19.png
Vertical
发表于 2025-3-25 02:28:46
http://reply.papertrans.cn/87/8675/867484/867484_20.png