LATHE
发表于 2025-3-26 22:44:48
http://reply.papertrans.cn/83/8230/822989/822989_31.png
indubitable
发表于 2025-3-27 05:09:21
Evaluation of Cylindricity Deviation from Coordinate Measurement Data using a Volume Hunting Methods of cylindricity deviations using ten coordinate measurement datasets from the literature. The proposed method has been found to yield lower cylindricity deviations with eight datasets and almost at par with two remaining datasets. Further, the cylindrical search volume has been found to be faster than the prismatic search volume.
吝啬性
发表于 2025-3-27 08:23:57
http://reply.papertrans.cn/83/8230/822989/822989_33.png
Aboveboard
发表于 2025-3-27 11:00:44
http://reply.papertrans.cn/83/8230/822989/822989_34.png
CARK
发表于 2025-3-27 16:42:51
Computational and Experimental Methods to Investigate Fracture Behavior of Functionally Graded Mates numerical methods used for the crack and fatigue analyses of FGMs. Finally, some vital suggestions for future scope of research in the area of FGMs are presented. It is hoped that this review paper will serve the interests of all the academicians, researchers, and engineers involved in the analysis and design of FGMs.
prostate-gland
发表于 2025-3-27 21:02:35
Investigation on the Machining of Inconel-718 Using EDM,eters. It has been found that “current” has the most significant impact on the response parameter (material removal rate). The study has also provided the combination for the largest possible material removal rate for the given set of process parameters based on the concept of larger the better optimality condition.
荣幸
发表于 2025-3-27 22:16:58
Generation of Tool Path in Fused Filament Fabrication,ented. Slicing algorithm, contour formation algorithms, and contour filling algorithm have been presented in this study. At the last, study on factors affecting material extrusion in fused filament fabrication process has been presented.
伦理学
发表于 2025-3-28 03:41:17
A Note on Preparation of Electroless Nickel Coating on Alumina Micro-particulates as the Forerunnerstudy would be used to develop the novel materials by incorporating the prepared particulates into the aluminum alloys, and subsequently, mechanical, tribological and machining studies can be conducted to attain the advantage of developed novel materials.
强所
发表于 2025-3-28 07:33:17
Recent Advances in Smart Manufacturing and MaterialsSelect Proceedings o
CARE
发表于 2025-3-28 12:05:02
http://reply.papertrans.cn/83/8230/822989/822989_40.png