Systemic
发表于 2025-3-27 00:24:17
Effect of Friction Stir Processing on Fatigue Properties of Al 6061-T6 Plates and Optimizing the FSby varying two sets of parameters. Static tests and Fatigue tests were carried out for Base and FSP material. Friction Stir Processing resulted in a significant improvement in fatigue life of FSP Al 6061-T6 plates when compared to base material, where static strength showed no improvement. One of th
变态
发表于 2025-3-27 01:36:21
Study of Dry Sliding Wear Behaviour of Aluminium MMC,istics. Al/B.C composites can be created using a variety of procedures, although stir casting is the most widely used method because it is the simplest and most affordable method. Nickel reinforcement in aluminium-based composites helps reduce the rate of abrasive wear. The quality of the bulk mater
Semblance
发表于 2025-3-27 05:39:45
http://reply.papertrans.cn/83/8229/822849/822849_33.png
Aids209
发表于 2025-3-27 13:15:40
Study of Friction Stir Processing on Al2219 Alloy, Surface Fabricated with B4C and Graphite Particuharacteristics. There were two types of specimens made. Specimen 1–friction stir processing was performed on base metal. Specimen 2–friction stir processing was performed on Al2219 plate with reinforcements. The processing direction was rotated by 180 degrees in between each pass. Wear analysis was
neologism
发表于 2025-3-27 13:52:50
Identification of Structural Damage Location and Severity Using Deep Learning,nce. Finding the location and severity of the damage could help in avoiding the possible catastrophe. There are a bunch of different NDTs to identify the damage, but these tests are time consuming and need a unique set-up and skilled human resources. So, to avoid these circumstances, modern techniqu
Conflict
发表于 2025-3-27 18:22:58
http://reply.papertrans.cn/83/8229/822849/822849_36.png
MILK
发表于 2025-3-27 23:10:24
http://reply.papertrans.cn/83/8229/822849/822849_37.png
Inkling
发表于 2025-3-28 06:03:55
http://reply.papertrans.cn/83/8229/822849/822849_38.png
cylinder
发表于 2025-3-28 06:49:31
http://reply.papertrans.cn/83/8229/822849/822849_39.png
Foment
发表于 2025-3-28 12:23:48
Optimization of Process Parameters in Friction Stir Processing for the Development of Polymer-Derivwas done keeping the parameters unchanged for different volume fractions of reinforcement and then the processed samples were characterized. It was found that, for the same processing parameters, the compatibility of mixing was not satisfactory for all the experiments with varying volume fractions.