overrule
发表于 2025-3-23 11:41:53
Improvement in the Design of Automobile Upper Suspension Control Arms Using Aluminum Alloys,y means of traditional engineering methods. Today we try to use the much lighter metal aluminum, to manufacture these parts instead of steel. Fuel consumption and emission of polluting gases are strongly dependent on car weight. So the automotive industry is looking at innovative technological proce
钉牢
发表于 2025-3-23 15:02:37
http://reply.papertrans.cn/27/2604/260302/260302_12.png
高脚酒杯
发表于 2025-3-23 20:17:07
http://reply.papertrans.cn/27/2604/260302/260302_13.png
迁移
发表于 2025-3-24 00:01:13
http://reply.papertrans.cn/27/2604/260302/260302_14.png
是限制
发表于 2025-3-24 05:53:30
Vibroacoustic Sources Identification of Gear Mechanism Transmission, Often, they are experimental statements on a significant number of transmissions which finish by councils given to the designers in order to limit or to reduce the radiated noise. Our work consists in contributing to treat on a hierarchical basis the vibroacoustic sources on a transmission system d
掺和
发表于 2025-3-24 08:18:19
Prediction of Structural and Dynamic Behaviors of Impacted Plates, of impacted plate. The established model, referred to a modified Hertzian contact law, has been validated and used to study the influence of different impact parameters. The obtained results are in good agreement with those given with the finite element simulations. The validated model has been use
情感
发表于 2025-3-24 12:54:01
Application of Structural INTegrity Assessment Procedure to Nuclear Power Plant Component,omprehensive assessment procedure is SINTAP- Structural INTegrity Assessment Procedure. The SINTAP introduced the basic principles of R6 (rev. 3) and ETM. SINTAP procedure is possible to performed assessment for inhomogeneous configurations such as strength mis-matched weldments and an effect of res
DEVIL
发表于 2025-3-24 17:49:11
Failure Assessment Diagrams in Structural Integrity Analysis,or a solid with a finite crack/U-notch under mode I loading. The cohesive stress is treated according to Von Mises yield criterion as a property of both the yield stress and the T-stress which was introduced into the criterion to quantify constraint in different geometries and type of loading. A bri
折磨
发表于 2025-3-24 20:24:00
http://reply.papertrans.cn/27/2604/260302/260302_19.png
闲逛
发表于 2025-3-25 02:41:53
http://reply.papertrans.cn/27/2604/260302/260302_20.png