maudtin
发表于 2025-3-30 08:35:00
Machining of Maraging Steel Through Al2O3 Abrasive Powder Assisted Electrochemical Discharge Machinith conductive and nonconductive materials. In the present study, the micro-hole is drilled on maraging steel at varying input parameters. Alumina (Al.O.) powder of average particles size 5–10 µm is mixed with NaOH electrolyte to analyze the influence of powder in machining performance. The variable
偏离
发表于 2025-3-30 13:56:05
http://reply.papertrans.cn/15/1490/148971/148971_52.png
Apoptosis
发表于 2025-3-30 18:03:59
Performance of Electrochemical Micromachining of Magnesium Alloy Through Sodium Nitrate Electrolytehining methods are under investigation throughout the world. This study presents the effect of various process parameters in electrochemical micromachining of magnesium alloy by using sodium nitrate electrolyte. Since micro-holes are found in biomedical and electronic parts, this investigation is hi
jettison
发表于 2025-3-31 00:39:43
http://reply.papertrans.cn/15/1490/148971/148971_54.png
音乐戏剧
发表于 2025-3-31 04:22:01
http://reply.papertrans.cn/15/1490/148971/148971_55.png
听写
发表于 2025-3-31 09:01:29
http://reply.papertrans.cn/15/1490/148971/148971_56.png
含铁
发表于 2025-3-31 11:11:50
Experimental Studies on Laser Marking Characteristics of Stainless Steel 304 for product identification and traceability. The paper focuses on the production of good quality laser marked surface of stainless steel 304 in a minimal possible time with good marking characteristics by fiber laser. The experiments were performed by scanning the fiber laser for a single pass. The
Glucose
发表于 2025-3-31 15:44:58
http://reply.papertrans.cn/15/1490/148971/148971_58.png
grotto
发表于 2025-3-31 18:55:00
Multi-objective Optimization of Powder Mixed Green-EDM Parameters on Machining of HcHcr Steel Using h i.e., CRITIC with TOPSIS & CRITIC with GRA. Here, the CRITIC method is used for extraction of precise weights of the output while TOPSIS & GRA is used for optimization of the green EDM. Experimentation is performed based on Taguchi’s L.-(OA) by varying inputs i.e., polarity (P), C., T., Toff & PC
Synthesize
发表于 2025-3-31 21:52:13
https://doi.org/10.1007/0-387-27622-Xolarity condition. Using reverse polarity has been found to increase the TWR as compared to normal polarity conditions. The machined surface obtained using reverse polarity has a better surface finish as compared to that obtained using the normal polarity condition. Using reverse polarity has been f