在驾驶
发表于 2025-3-27 00:35:48
http://reply.papertrans.cn/15/1490/148971/148971_31.png
多产子
发表于 2025-3-27 04:27:04
http://reply.papertrans.cn/15/1490/148971/148971_32.png
发怨言
发表于 2025-3-27 05:59:25
Experimental Investigation into Electrochemical Discharge Milling of Glass by Bottom Feeding the Toolled machining chamber. The effects of three different parameters like voltages, electrolyte types and dwell time on performance characteristics have been studied. Good quality machining surface is obtained at lower voltage and higher dwell time in NaOH electrolyte solution.
ALIBI
发表于 2025-3-27 11:05:19
Machining of Maraging Steel Through Al2O3 Abrasive Powder Assisted Electrochemical Discharge Machinierformance is evaluated in terms of material removal rate (MRR). With MINITAB software, the experimental layout for this study is designed using Response Surface Methodology (RSM) with Box-Behnken. It is observed that at parameters voltage 45 V, duty factor 35%, and Al.O. powder concentration of 3 wt.%/vol shows higher MRR.
calorie
发表于 2025-3-27 14:16:06
Performance Analysis of Dynamic Magnetic Field-Assisted Electrochemical Spark Drillingocess are: (i) voltage, (ii) electrolyte concentration, (iii) tool speed and (iv) magnetic field intensity. Experimental results indicate that for higher MRR, voltage and electrolyte concentrations are the most significant factors followed by magnetic field intensity and tool speed.
THROB
发表于 2025-3-27 21:05:29
http://reply.papertrans.cn/15/1490/148971/148971_36.png
heterodox
发表于 2025-3-27 23:48:27
Vitaliy A. Yatsenko,Panos M. Pardalosgives higher MRR in hybrid machining process. Further, the results obtained for hybrid process are optimized for maximum MRR. Lorentz force developed by virtue of magnetic field and activated carbon in the sparking zone attributed to MRR enhancement.
ORE
发表于 2025-3-28 05:08:11
From MAD to Cooperative Threat Reduction,is a non-traditional machining process. The effect of the different WEDM process parameters on the output responses is analyzed with the help of Box-Behnken Design (BBD) of Response Surface Methodology (RSM) optimization technique. Confirmatory tests are also conducted to validate the experimental results in the present research work.
Onerous
发表于 2025-3-28 09:47:18
The Problem with ‘Awareness’ (2002)vealed that laser power of 20 W, scanning speed of 20 mm/s and pulse frequency of 105 kHz seem to be appropriate parameters which could be selected for better value of marking characteristics such as mark intensity and mark width.
Nostalgia
发表于 2025-3-28 11:30:13
Improving Material Removal Rate in Machining of Micro-holes Using Hybrid EDM Processgives higher MRR in hybrid machining process. Further, the results obtained for hybrid process are optimized for maximum MRR. Lorentz force developed by virtue of magnetic field and activated carbon in the sparking zone attributed to MRR enhancement.