fatty-streak
发表于 2025-4-1 05:41:44
https://doi.org/10.1007/978-4-431-65910-5Al7075-TiC composites. The MMCs are made by adding 6 wt% of red mud and same percentage of TiC separately using stir casting method. Once the specimens are made, machining characteristics of the said AMMCs are studied by using electric discharge machining (EDM). During experimentation, investigation
Countermand
发表于 2025-4-1 08:36:33
https://doi.org/10.1007/978-4-431-65910-5hness were studied against the wire cut EDM process parameters, namely pulse ON time, pulse OFF time, voltage and wire feed rate. The pulse ON time selected for the experiment was 4, 5, 6 µs, and pulse OFF time is 6, 8, 10 µs. The voltage values selected in the experiment are 50, 65 and 85 V, while
托人看管
发表于 2025-4-1 10:57:29
https://doi.org/10.1007/978-981-15-5988-4apidly, increase in global warming, and concern on environmental pollution. The development of the green composites is also increased for the fact that the properties of these are very similar to synthetic composites. Water hyacinth plant is an aquatic plant which causes several devastating problems
Kidney-Failure
发表于 2025-4-1 16:12:17
https://doi.org/10.1007/978-981-15-5988-4d current tungsten inert gas (PCTIG) welding technique has been employed. Experimental investigations were carried out using TIG welding and PCTIG welding with AC and DC currents on dissimilar joints of copper and brass and mechanical properties such as microhardness were compared. AC-PCTIG with 5 H