gnarled
发表于 2025-3-30 09:19:36
http://reply.papertrans.cn/83/8283/828203/828203_51.png
Hippocampus
发表于 2025-3-30 12:47:53
Influence of Thermographic Image Filtering on Hybrid TSA, study deals with the influence of filtering operations on the results of the method. Synthetic TSA stress fields corrupted by added noise are considered. Gaussian filters are then applied to reduce the difference between theoretical and reconstructed TSA stresses using a reduced number of points on
BRAND
发表于 2025-3-30 18:11:24
Optical Analysis of Residual Stress with Minimum Invasion,that thermal expansion causes tensile residual stress along the weld line and that the effect is greater at the ending side of butt-welding than starting side. The maximum tensile residual stress along the weld line is estimated to be 76.9 ± 12.8 MPa.
Mendicant
发表于 2025-3-30 21:29:56
Detection of Early Stage Material Damage Using Thermophysical Properties,ded using high speed camera. Changes in thermophysical properties including heat transfer rate (Q), thermal conductivity (k), heat capacity (c) were computed as functions of fatigue cycles. Preliminary data shows that the time-temperature (T-t) evolution is correlated to the number of fatigue cycles
Capitulate
发表于 2025-3-31 04:19:53
Repeatability of Contour Method Residual Stress Measurements for a Range of Material, Process, andregions of higher repeatability along the part perimeter. The repeatability standard deviations over most of the cross-section range from 5 MPa, for the aluminum T-section, to 35 MPa, for the stainless steel forging. These results provide expected precision data for the contour method over a broad
向下五度才偏
发表于 2025-3-31 06:41:18
http://reply.papertrans.cn/83/8283/828203/828203_56.png
可用
发表于 2025-3-31 09:10:44
Influence of Printing Constraints on Residual Stresses of FDM Parts,ts of printed parts, both on top and bottom, in order to verify if the constrain conditions used during the printing produce substantial variation from a point to another. The residual stresses have been measured in ABS parts employing the hole-drilling method. In order to avoid the local reinforcem
Temporal-Lobe
发表于 2025-3-31 13:22:26
Jun-Sang Park,John Okasinski,Jonathan Almer,Paul Shade,T. J. Turnery adopted within the crop-plant research community to gain such a foothold. By considering primarily the expressed sequence tag resources, we have explored how even moderately simple genomic resources may be exploited in molecular marker development, candidate gene selection and microarray-based gen
minimal
发表于 2025-3-31 17:35:17
http://reply.papertrans.cn/83/8283/828203/828203_59.png
不来
发表于 2025-4-1 01:35:14
http://reply.papertrans.cn/83/8283/828203/828203_60.png