TAP
发表于 2025-3-23 13:16:27
2195-4356 ent aspects of designing, modeling, manufacturing, optimizing, and processing with wide ranging applications. The contents of this book can be of interest to researchers and professionals alike..978-981-15-1126-4978-981-15-1124-0Series ISSN 2195-4356 Series E-ISSN 2195-4364
Arroyo
发表于 2025-3-23 16:27:52
http://reply.papertrans.cn/83/8235/823476/823476_12.png
angiography
发表于 2025-3-23 19:40:31
Analysis Over Trio-Tube with Dual Thermal Communication Surface Heat Exchanger ,eat exchanger on the same parameters. It was observed that the pipe length for T.T.H.Xr reduced by ~58.39% compared to the double-tube heat exchanger to extract the same amount of heat transfer from the hot fluid.
jeopardize
发表于 2025-3-23 22:10:30
http://reply.papertrans.cn/83/8235/823476/823476_14.png
刺穿
发表于 2025-3-24 04:31:03
http://reply.papertrans.cn/83/8235/823476/823476_15.png
Misgiving
发表于 2025-3-24 09:43:57
Performance, Combustion, and Emission Characteristics of Diesel Engine Fuelled with Waste Cooking Oed upon experimentation clearly show that the BTE increases marginally (14.285%) for iron oxide nanoparticles (for 75 ppm) blended WCOME while BSEC decreases (26%) when compared to other blends. The emission levels of oxides of nitrogen (4.87%), carbon oxide (16%), and unburnt hydrocarbons (10%) are
Engaged
发表于 2025-3-24 12:24:28
Effect of Multiple Injection Strategy on Combustion of Cotton Seed Oil Biodiesel in CRDI Diesel Eng. In this work multiple injection strategy is used for improving combustion process in CRDI diesel engine for having better compromise in the requirements for the reduction of NOx and smoke emission. Biodiesel blend B20 is prepared from nonedible cotton seed oil using transesterification process. Co
cataract
发表于 2025-3-24 16:46:33
Development of Solar Turbine for Small-Scale Industries,. The superiority in this design is utilization of smart fluid in substitute of water. The advantage of using smart fluid is that it vaporizes at relatively low temperature compared to water which needs high temperature to vaporize. Design and development of such device is taken up as research work.
laparoscopy
发表于 2025-3-24 20:51:48
http://reply.papertrans.cn/83/8235/823476/823476_19.png
左右连贯
发表于 2025-3-25 01:09:41
Experimental Investigation on Stir Casting Processing and Properties of Al 6082/SiC Metal Matrix Co the ASTM E8/E8 M-08. The strength under tension is maximum for the 10% SiC MMC with the value of 169.94 MPa is achieved. The hardness test results reveal that the 0% SiC has highest hardness number of 57.8 HRB. From the microstructural investigation, it is observed that clustering of the particulat