发展
发表于 2025-3-25 06:00:34
Processibility Analysis of Rotationally Moldable Linear Low-Density Polyethylene/Glass Fiber Blendce of LLDPE and 15% or below marks unsuitability as glass fiber peaks hardly prevails. Thus, it can be inferred from the experiment that approximately 20% of glass fiber combined with LLDPE can be considered as a suitable blend range, making it appropriate for rotomolding processability, ensuring th
formula
发表于 2025-3-25 08:18:52
Rejection Rate Minimization of Cast Iron Components Through Metallurgical Analysis It helps to identify if the carbon equivalent falls in the required range or not. Thirdly, microstructure of the material was studied before and after etching by employing optical microscopy test and phase analysis by XRD. In addition, the mechanical properties of the cast materials were studied us
责怪
发表于 2025-3-25 12:32:51
An Effect of Process Parameter on Physical Appearance of Deposited Friction Surfaced Layer: A Feasibdifferent parameters, rotational speed, travers speed, tilt angle and with rate of feeding a set of trials are performed. Effect of friction surfacing parameters on bond width, bond length and consumable rod ring shape investigated experimentally. Final set of parameters is obtained with effective b
考古学
发表于 2025-3-25 18:04:56
http://reply.papertrans.cn/83/8229/822874/822874_24.png
拖网
发表于 2025-3-25 23:39:12
http://reply.papertrans.cn/83/8229/822874/822874_25.png
图画文字
发表于 2025-3-26 04:09:59
A Review of Challenges to Hastelloy – C Series Weld Overlayed phase (TCP), transformation sequence of Hastelloy C-4, C-276, and C-22. The importance of dilution for weld overlay, selection of welding process, selection of filler wire, recommended joint geometry, and weld sequencing for Hastelloy – C series weld overlay has been discussed in detail. This rev
dyspareunia
发表于 2025-3-26 04:40:49
http://reply.papertrans.cn/83/8229/822874/822874_27.png
追逐
发表于 2025-3-26 10:44:45
Applicability of Bobbin Tool Friction Stir Welding for Dissimilar Al-Mg Jointnd groove, and material sticking to the tool pin is observed. Pin length, bigger diameter of the lower shoulder and flat surface of tool shoulder without chamfered edge are considered to be responsible for flash and groove defects. Process parameters which could have restricted joint formation are d
humectant
发表于 2025-3-26 12:55:59
http://reply.papertrans.cn/83/8229/822874/822874_29.png
表示向前
发表于 2025-3-26 20:45:31
Reliability Analysis of Car Subsystem by Weibull Two Parameter Analysisuspension were calculated, and suggestions were provided accordingly. Obtained results show that the failure of systems follows the pattern of clutch, front brake, suspension and rear brake according to the travelled distance. The results and associated analysis may be used to calculate the reliability of other car systems of similar segments.