新字
发表于 2025-3-30 10:53:27
Forming Temperature Investigation of Aluminum and Aluminum/Silicon Carbide Using Image Texture Feats. In the present work, the effect of forming temperature on the forming behavior of aluminum and aluminum reinforced by 10 wt% SiC was studied by using image texture features after using the compression test which was done at an elevated temperature range of 300–550 °C and a constant strain rate of
招致
发表于 2025-3-30 12:59:25
http://reply.papertrans.cn/63/6209/620839/620839_52.png
指数
发表于 2025-3-30 17:35:46
,The Influence of Two Different Casting Moulds on the Fatigue Properties of the Al–Si–Cu Cast Alloy, parameters (especially eutectic Si particles and Fe-rich intermetallic phases) has considerable influence on fatigue properties in both types of experimental materials. The results show that the fatigue lifetime is longer for samples casted into a metallic mould (chill casting) (average fatigue lif
GROUP
发表于 2025-3-30 21:05:13
http://reply.papertrans.cn/63/6209/620839/620839_54.png
omnibus
发表于 2025-3-31 03:07:14
http://reply.papertrans.cn/63/6209/620839/620839_55.png
纬线
发表于 2025-3-31 06:05:49
The Material Hardness and Tensile Strength of AA5083 Aluminum Alloy Friction Stir Welding Lap Jointes after attaining marginal speed. Deflections of friction stir welded specimens and base materials were compared and they exhibited almost similar trends at different spots in the welding nugget, heat affect zone and thermal material affected zone of all the specimens [.–.].
cloture
发表于 2025-3-31 11:42:11
Mechanism of Creating the Topography of an Abrasive Water Jet Cut Surface,a which has not received much attention. In material disintegration, the mechanisms of cutting, plastic deformation, fatigue and fracture participate physically. By studying the surface topography we can better understand the process of abrasive water jet machining, specify the theory and correctly
忘川河
发表于 2025-3-31 16:37:46
http://reply.papertrans.cn/63/6209/620839/620839_58.png
lacrimal-gland
发表于 2025-3-31 21:03:26
Laser Beam Machining, Laser Beam Hybrid Machining, and Micro-channels Applications and Fabricationmainly classified into seven categories named as: (1) Introduction, (2) Laser Beam Machining (LBM), (3) Laser Assisted Machining (LAM), (4) Laser Chemical Machining/Etching (LCM/E), (5) Laser Assisted Electrochemical Machining (LAECM) and (6) Under-Water Laser Ablation (UWLA) and (7) Micro-channel
极少
发表于 2025-4-1 00:34:27
Book 2016ny cases, forming and machining technologies require additional post-treatment to achieve the required level of surface quality or to furnish a protective layer. Accordingly, sections on laser treatment, shot peening and the production of protective layers round out the book’s coverage..