sinoatrial-node
发表于 2025-3-28 16:07:18
Stainless Steel Deep Hole Drilling with EDM,ectrode inner flushing. Experiments also showed the machining feed rate increases with a decreasing dielectric oil flushing pressure. There was not found any limit in the hole depth up to the depth of 48 mm in stainless steel, even for a low-level flushing corresponding to dropping of individual dro
Endearing
发表于 2025-3-28 19:53:30
http://reply.papertrans.cn/47/4672/467147/467147_42.png
palliate
发表于 2025-3-29 01:18:01
http://reply.papertrans.cn/47/4672/467147/467147_43.png
色情
发表于 2025-3-29 06:19:52
Study of Thermostable Polyurethane Material Produced by Robotic Milling Machining,n made. The CAM programming has been obtained with the Software Powermill® of the company DELCAM, taking into account two types of strategies for limiting the freedom degree of the robot, to verify geometric results. Finally it has been measured and analyzed the surface generated by interferometer a
admission
发表于 2025-3-29 07:16:55
http://reply.papertrans.cn/47/4672/467147/467147_45.png
APO
发表于 2025-3-29 15:29:30
http://reply.papertrans.cn/47/4672/467147/467147_46.png
琐碎
发表于 2025-3-29 17:14:21
http://reply.papertrans.cn/47/4672/467147/467147_47.png
CODE
发表于 2025-3-29 22:58:55
,Cycle Time Reduction in CNC Turning Process Using Six Sigma Methodology – A Manufacturing Case Stud for the best cutting conditions are proposed for industrial production using the formulated mathematical model. Finally, this paper documents the analysis and tasks performed that reduced cycle time which resulted in increased productivity and also in annual savings.
品牌
发表于 2025-3-30 00:28:01
Technology Foresight to Enable New R&D Collaboration Partnerships: The Case of a Forestry Company,was used to create a new R&D collaboration in the company under study, while identifying what motivated such collaboration and how it was managed. Furthermore, important characteristics of the team responsible for that process and of the process management are highlighted.
Ceramic
发表于 2025-3-30 04:52:03
Study of Heat Transfer Conditions in the Cutting Zone When Grinding,olant under the action of an air jet from both sides is uncovered. It’s determined that the overlap pattern largely depends on the input air pressure and the size of the annular gap between the workpiece and the inner surface of the end elements of the coolant supply device. Construction measures th