heterogeneous
发表于 2025-3-25 06:16:56
http://reply.papertrans.cn/39/3862/386161/386161_21.png
CROW
发表于 2025-3-25 10:53:42
http://reply.papertrans.cn/39/3862/386161/386161_22.png
abnegate
发表于 2025-3-25 11:54:33
Conference proceedings 1999 the University of Twente, Enschede, TheNetherlands. .This volume presents the theory and application of consistenttolerancing. Until recently CADCAM systems did not even address theissue of tolerances and focused purely on nominal geometry. Therefore,CAD data was only of limited use for the downstr
完全
发表于 2025-3-25 17:45:35
Optimising Tolerance Allocation for Mechanical Assemblies Considering Geometric Tolerances Based on rithm. Through the implementation of an illustrated example, it is shown that the efficiency is remarkably high. This approach is also effective for the general cases of nonlinear and large-scale tolerance allocation optimisation problems.
FORGO
发表于 2025-3-25 21:46:49
http://reply.papertrans.cn/39/3862/386161/386161_25.png
Water-Brash
发表于 2025-3-26 00:57:09
http://reply.papertrans.cn/39/3862/386161/386161_26.png
退出可食用
发表于 2025-3-26 05:50:37
https://doi.org/10.1007/978-94-009-2490-1he workpiece orientation and location while clamped, and sufficient contact and clamping forces. Vectorial Tolerancing principals are also used to design measuring equipment used in the forging department to measure the clamp ability of the forged parts.
表皮
发表于 2025-3-26 08:59:41
Lymphocyte Apoptosis in HIV Infectioncutting processes can be selected for satisfying the assigned geometric tolerance. It is also to be used in the inspection planning process for the determination of measurement points and measurement sequences in 3D coordinate measuring machines.
贵族
发表于 2025-3-26 15:39:43
Industrial application of Vectorial Tolerancing to improve clamping of forged workpieces in machininhe workpiece orientation and location while clamped, and sufficient contact and clamping forces. Vectorial Tolerancing principals are also used to design measuring equipment used in the forging department to measure the clamp ability of the forged parts.
清楚说话
发表于 2025-3-26 19:44:21
Tolerance Representation Scheme for Integrated Cutting Process & Inspection Planningcutting processes can be selected for satisfying the assigned geometric tolerance. It is also to be used in the inspection planning process for the determination of measurement points and measurement sequences in 3D coordinate measuring machines.