托运
发表于 2025-3-28 18:39:39
http://reply.papertrans.cn/32/3109/310865/310865_41.png
名字
发表于 2025-3-28 19:06:18
Stresses and Strains in Axially Loaded Members,in axially loaded members for cases in which the applied axial load was either a constant, or varied in some fashion along the length of the member. The concept of the axial force diagram was also developed to show the way the internal axial force in a member varies along the length of the member.
intuition
发表于 2025-3-29 02:10:15
http://reply.papertrans.cn/32/3109/310865/310865_43.png
enterprise
发表于 2025-3-29 06:55:57
Stresses in Beams,systems. These members are called upon to resist bending action that is usually produced either by loads that are perpendicular to the member (transverse loads) or by pure bending moments. Regardless of the way the beam is loaded, the resulting action leads to two effects that are of major significa
agonist
发表于 2025-3-29 07:25:41
Deflections of Beams,to repair, may occur in buildings. Shafts acting in bending may become misaligned in their bearings due to large deflections, resulting in excessive wear and possible malfunction. High-rise structures, which contain beam components, may deflect enough to cause psychological stress among the occupant
橡子
发表于 2025-3-29 13:50:02
http://reply.papertrans.cn/32/3109/310865/310865_46.png
Bother
发表于 2025-3-29 15:53:34
Introduction to Component Design,ansverse forces, to torques, and to bending moments as well as to combinations of these effects. In all instances, methods were developed to compute the stresses and deformations resulting from a given set of loading conditions.
Popcorn
发表于 2025-3-29 23:05:53
Analysis and Design for Inelastic Behavior,o load capacity. In Chapter 10 computed stresses associated with service or working loads were compared to allowable stresses. These allowable stresses were determined by applying a factor of safety to some “ failure ” stress. Traditional designs of the past as well as much current engineering pract
Wallow
发表于 2025-3-30 01:38:30
Analysis and Design for Impact and Fatigue Loadings,t in dynamic analysis and design are considered: impact and fatigue loadings. For example, highway and railway bridges are subjected to impact loading as vehicles cross them and allowances for such loadings are made in their design. High-speed machines contain many moving parts that are subjected to
鞠躬
发表于 2025-3-30 08:06:11
http://reply.papertrans.cn/32/3109/310865/310865_50.png