ADJ
发表于 2025-3-23 12:06:03
http://reply.papertrans.cn/31/3057/305661/305661_11.png
付出
发表于 2025-3-23 17:54:04
The Sigma Society: A Dynamic ModelThis chapter will examine Ohm’s law, which details the current–voltage relationship for resistors. The voltage . across the resistor and the current . through the resistor obey the law of . = ., where . is the resistance of the resistor.
resistant
发表于 2025-3-23 18:41:01
http://reply.papertrans.cn/31/3057/305661/305661_13.png
commonsense
发表于 2025-3-24 01:36:23
https://doi.org/10.1007/978-4-431-67887-8In this chapter, we will discuss Kirchhoff’s current law (KCL). This law concerns about what happens for currents from different branches or paths meet at one “intersection.” Since the flow of electrical charges cannot stop at the “intersection,” the charges flowing into the “intersection” must equal to the charges leaving the “intersection.”
BOLT
发表于 2025-3-24 02:25:11
https://doi.org/10.1057/9780230377783This chapter will go over what it means for components to be connected in series or in parallel, with an emphasis on resistors. When resistors are connected in series, the effective resistance increases. When the resistors reconnected in parallel, the effective resistance decreases.
hypotension
发表于 2025-3-24 08:52:19
http://reply.papertrans.cn/31/3057/305661/305661_16.png
ambivalence
发表于 2025-3-24 13:16:24
http://reply.papertrans.cn/31/3057/305661/305661_17.png
Mercantile
发表于 2025-3-24 18:24:56
https://doi.org/10.1007/978-3-322-93771-1This chapter will describe how to build and simulate circuits using the computer simulation software .. Doing computer simulation is an important step to test the feasibility of the circuit that you designed. You can use the computer simulation to predict what the circuit will behave before you construct the circuit.
Forehead-Lift
发表于 2025-3-24 21:12:30
http://reply.papertrans.cn/31/3057/305661/305661_19.png
浓缩
发表于 2025-3-25 00:18:02
Falko Bause,Heinz Beilner,Jan KriegeThis chapter will discuss power and how to find the maximum power transfer from the source to the load. The maximum power transfer is achieved if the load resistance is the same as the resistance in the Thévenin or Norton equivalent circuit for the source.