Pantry
发表于 2025-3-25 06:38:28
http://reply.papertrans.cn/29/2804/280370/280370_21.png
cogitate
发表于 2025-3-25 08:31:18
http://reply.papertrans.cn/29/2804/280370/280370_22.png
擦掉
发表于 2025-3-25 12:09:07
http://reply.papertrans.cn/29/2804/280370/280370_23.png
观点
发表于 2025-3-25 18:48:15
Waste Quantities and Characteristics,cific heat capacity, thermal conductivity, absorption of laser radiation, Young’s modulus, yield strength, ultimate tensile strength, Poisson’s ratio, and the coefficient of thermal expansion. These are modeled for solid as well as powder material.
硬化
发表于 2025-3-25 23:19:13
Christine Furedy,Raakhee Kulkarni The full design procedures including process simulation are described. The parts are manufactured and evaluated following the benchmark procedure. It is shown that for production scales larger than single-part production, the research hypothesis is proven valid without any exception.
浓缩
发表于 2025-3-26 00:31:17
http://reply.papertrans.cn/29/2804/280370/280370_26.png
Glycogen
发表于 2025-3-26 05:38:08
R. B. Thompson,O. Buck,D. K. Rehbeinis was proven valid and the developed design methodology of algorithmic support structure design successful. Cost reduction is achieved, whereas the technical performance is satisfactory and even slightly increases compared to the standard block support type. An outlook on subjects in need of further research is given.
Fecal-Impaction
发表于 2025-3-26 10:39:56
Conclusion,is was proven valid and the developed design methodology of algorithmic support structure design successful. Cost reduction is achieved, whereas the technical performance is satisfactory and even slightly increases compared to the standard block support type. An outlook on subjects in need of further research is given.
Angiogenesis
发表于 2025-3-26 13:40:47
Introduction,ired experience hinder the adoption of additive manufacturing. With regard to laser powder bed fusion of metals, the support structures are a key factor related to all these issues. Hence, this thesis deals with the digitalization of support structure design to contribute to an increase in additive manufacturing adoption.
大漩涡
发表于 2025-3-26 18:47:01
Support Structure Design,d the design rules of chapter 5 are implemented. The complete tree support modeling procedure is described in detail and validated against the topology optimization results used to derive the design rules.