Multiple
发表于 2025-3-25 05:37:39
Book 2017hology–property correlations of thermoplastics, elastomers and polymer resins. Each chapter of this book gives a comprehensive review of state-of-the-art methods of materials testing and diagnostics, tailored for plastic pipes, films and adhesive systems as well as elastomeric components and others.
充满人
发表于 2025-3-25 09:10:43
Deformation and Fracture Behaviour of Polymer Materials978-3-319-41879-7Series ISSN 0933-033X Series E-ISSN 2196-2812
aesthetic
发表于 2025-3-25 13:40:56
Putting into Geometrical Contexts,as analysed both from the experimental and analytical point of view. For blends composed of polyurethane (TPU) and an acrylonitrile–butadiene–styrene copolymer (ABS), it has been shown that the stop block method in multiple-specimens technique is the most suitable method for determining R-curves at
Scintigraphy
发表于 2025-3-25 19:07:23
http://reply.papertrans.cn/27/2649/264840/264840_24.png
绊住
发表于 2025-3-25 23:52:29
Jonas Almqvist,Malena Lidar,Anette Oling methods. Uncertainties may arise from deviating parameters such as changes in environmental conditions, temperature, different loading ratios, chemicals such as stress cracking agents, etc. Only when these influences are known it is justifiable to go into lifetime calculations. Own studies showed,
津贴
发表于 2025-3-26 02:43:39
http://reply.papertrans.cn/27/2649/264840/264840_26.png
品尝你的人
发表于 2025-3-26 07:16:55
https://doi.org/10.1007/0-306-47204-Xted, α- and β-nucleated PP are presented. These materials were prepared under different cooling rates to influence the degree of crystallinity within the materials. The materials resistance against stable crack propagation was described by R-curves. The ..–Δ. curves were determined using the instrum
thrombosis
发表于 2025-3-26 11:47:58
http://reply.papertrans.cn/27/2649/264840/264840_28.png
ESPY
发表于 2025-3-26 13:11:07
https://doi.org/10.1007/978-3-662-64660-1ional SEM (CSEM), the variable pressure SEM (VPSEM) and the environmental SEM (ESEM) enable different investigation techniques for analysis. In this article special modes of performance are discussed. These are the low-voltage mode of the CSEM for the characterisation of surfaces without preparation
Indent
发表于 2025-3-26 17:50:44
Hans-Wolfgang Henn,Andreas Fillernterpretations of the fracture behaviour of such polymers are based on results gained from completely fractured samples. To gain deeper insight into the fracture mechanisms the focus was put on the very early stages of the fracturing process. For this purpose tensile tests of the samples were stoppe