defuse
发表于 2025-3-25 03:23:27
http://reply.papertrans.cn/24/2333/233246/233246_21.png
色情
发表于 2025-3-25 10:40:14
978-3-031-42989-7The Editor(s) (if applicable) and The Author(s), under exclusive license to Springer Nature Switzerl
LAIR
发表于 2025-3-25 12:43:44
Shaofan LiPresents the state of the art in computational and Experimental engineering.Features papers from the Int‘l Conference on Computational & Experimental Engineering and Sciences (ICCES 2023).Written by l
喷出
发表于 2025-3-25 19:11:55
http://reply.papertrans.cn/24/2333/233246/233246_24.png
incarcerate
发表于 2025-3-25 21:12:46
http://reply.papertrans.cn/24/2333/233246/233246_25.png
责难
发表于 2025-3-26 00:41:05
https://doi.org/10.1007/BFb0069620re were designed under known target mass flow rate conditions, with a design time of 0.014 s. Numerical simulation verification showed that the maximum relative error and average relative error between the designed mass flow rate and the target value were 2.9% and 1.54%, respectively, demonstrating
小卷发
发表于 2025-3-26 08:18:29
https://doi.org/10.1007/BFb0069620d PC are explored by prototype test. The main conclusions are summarized as follows: (1) the bearing capacity of the wet-joint is much higher than the actual need after 3-day maintenance; (2) the waterproofing performance of the interface by the laboratory test meets the design requirements; (3) the
合乎习俗
发表于 2025-3-26 10:00:36
http://reply.papertrans.cn/24/2333/233246/233246_28.png
杂役
发表于 2025-3-26 16:26:45
https://doi.org/10.1007/BFb0069620pose and specialized perspectives. On this basis, a framework for building cybersecurity knowledge graphs is summarized, and key techniques for building cybersecurity knowledge graphs, including ontology construction, information extraction, and knowledge reasoning, are detailed. Finally, applicatio
暗讽
发表于 2025-3-26 18:43:16
https://doi.org/10.1007/BFb0066669ection, and occurrence time of the fracture, corresponding characterization and extraction methods also were proposed. The established parameter system can be used to solve reverse problems such as failure mode pre-diction and load estimating.