可商量
发表于 2025-3-26 22:39:08
Predictive Process Design Kits,suitable system, before it enters the work cylinder, i.e., to precompress the charge. In doing so, the temperature of the working medium should not be markedly raised, since this would adversely influence the temperature profile of the high-pressure work cycle.
意见一致
发表于 2025-3-27 02:27:44
https://doi.org/10.1007/978-1-4614-0445-3ompressing the work medium, i.e., air. It utilizes the exhaust gas energy which otherwise — due to the geometrically given expansion ratio of the crank mechanism — would be lost at the end of the high-pressure cycle. Simultaneously, the boundary conditions for combustion and the high-pressure cycle
Instantaneous
发表于 2025-3-27 08:35:35
http://reply.papertrans.cn/23/2241/224080/224080_33.png
carotenoids
发表于 2025-3-27 12:33:18
http://reply.papertrans.cn/23/2241/224080/224080_34.png
极肥胖
发表于 2025-3-27 17:30:41
https://doi.org/10.1007/978-1-4614-0445-3iate between passenger car and truck requirements. Off-road and tractor concerns can be treated as a subgroup of truck requirements. And requirements for locomotives largely correspond to those of stationary engine operating conditions. The special requirements of the latter vehicle categories will
不透气
发表于 2025-3-27 19:07:59
https://doi.org/10.1007/978-3-030-59396-4ered for such verifications, e.g., pressures, temperatures, mass flows, power, and speed. In this chapter we present a very compact overview of the preferred measuring techniques and devices used for data acquisition. For a more detailed study of this subject we refer to the pertinent literature [11
高脚酒杯
发表于 2025-3-27 22:11:30
https://doi.org/10.1007/0-387-27554-1 low emissions. Therefore, special attention has to be paid to the layout of charge air cooling systems and their components for specific engine concepts and applications. For this purpose, knowledge about different cooler designs and suitable charge air cooling systems is as important as knowledge
休息
发表于 2025-3-28 03:50:46
Charging the Internal Combustion Engine978-3-211-47113-5Series ISSN 1613-6349
Limpid
发表于 2025-3-28 08:48:00
Predictive Process Design Kits,suitable system, before it enters the work cylinder, i.e., to precompress the charge. In doing so, the temperature of the working medium should not be markedly raised, since this would adversely influence the temperature profile of the high-pressure work cycle.
Maximize
发表于 2025-3-28 10:37:36
Predictive Process Design Kits,With this characteristic it exhibits the best possible load response behavior. Its power and torque increase only depend on the rate of increase in the amount of fuel injected — if injection timing and combustion efficiency are considered nearly constant and the speed change is small in comparison to the change in the amount of fuel injected.