nettle
发表于 2025-3-28 14:54:50
CNC Programminghining. CNC machines the basic concepts of the machine are to control the motion of the tool, by means of set of instruction, which are prepared by programmer of operator. The set of programmed instructions are called the “program” or part programming of CNC machine tool. These instructions are only
reserve
发表于 2025-3-28 19:36:38
http://reply.papertrans.cn/23/2204/220379/220379_42.png
散开
发表于 2025-3-28 23:17:07
Milling Operationre being used while preparation of part programs. The major challenge in the part programming phase of the Milling operation is to deal with various complex shapes and structure to be machined which requires a complicated set of part programs that needs to be highly efficient, less time consuming an
intellect
发表于 2025-3-29 04:24:35
Five Axis CNC Machinesled using a single controller or are performed in a single umbrella. The 5 axis CNC machine, as the name suggests, allows control over 5 axes. 3 axes in the tool and 2 in the workpiece holder. Hence practically it can machine any geometry irrespective of the extent of complexity. Moreover, with the
Generosity
发表于 2025-3-29 08:01:25
http://reply.papertrans.cn/23/2204/220379/220379_45.png
横截,横断
发表于 2025-3-29 11:42:28
http://reply.papertrans.cn/23/2204/220379/220379_46.png
Interregnum
发表于 2025-3-29 16:49:55
Do Loop Cycleionalized cycle is Do-loops. .. In some jobs certain parts are required to be repeated. Instead of writing the program again and again Do-loops are implemented on incremental mode where the previous position is taken as the reference for next iteration. Do-loop reruns the program till no. of similar
Emasculate
发表于 2025-3-29 20:15:26
https://doi.org/10.1007/978-3-531-94000-7Ethnographie; Kultur; Moral; Neue Soziale Bewegungen; Soziologie